Up/Down Needle Position Button
RED LED | GREEN LED | Press this button to bring the needle up or down. |
|
| The RED LED will light up when the needle is |
|
| down. The GREEN LED will light up when the |
|
| needle is up. |
|
| The machine will stop with the needle up or down |
|
| depending on the needle position determined by |
|
| this button. |
|
| The machine will always stop with the needle up |
|
| after auto thread cutting or buttonhole sewing. |
Bobbin Winding Button
LED
Press this button to wind the bobbin.
The LED will light up when you shift the bobbin winding lever toward the bobbin and press this button.
The LED signal will turn off after bobbin winding is finished.
Thread Cutter Button
Stitch Length Adjustment Dial
3
q
Pressing this button after sewing will trim the threads.
You can continue sewing without pulling the bobbin thread up after using thread cutter.
•Use the thread cutter on the face cover if the thread is heavier than #30.
•The foot control and up/down needle position button cannot be used while the machine is trimming the threads.
You can adjust the stitch length from 0 to 6mm by turning this dial. The stitch length chosen will be shown on the stitch length display q.
Reverse Stitch Lever
The machine will sew in reverse while the reverse stitch lever is pressed down. The machine will sew forward when the lever is released.
Use the reverse stitch lever to secure the beginning and end of a seam.
7