ASSEMBLY INSTRUCTIONS
•Place Base Extensions
(A) as illustrated and snap Base Connector (B) firmly onto Base Extensions (Fig. 1).
•Insert the Adjustable Pole (C) into the Base by lining up the recessed slot in the Pole to the
raised dot on the Base Connector and push in. Be sure that the Pole is fully seated. Hold the Base firmly and twist the Pole CLOCKWISE 90° until it stops. DO NOT
•Adjust to the desired height and tighten the Height Adjustment Knob
(D) (Fig. 3).
Fig. 1 |
B |
A |
Fig. 2
C
Fig. 3 |
D |
HEIGHT |
ADJUSTMENT KNOB |
ATTACHING THE MOTOR ASSEMBLY TO THE FAN POLE
•Place the Motor Assembly (E) onto the Adjustable Pole and screw into place by turning Clockwise (Fig. 4). Align the slot to slide the latch into place (Fig. 5). NOTE: The tilt angle of the Motor Assembly can be changed by simply tilting the Motor up or down.
•Remove the Blade Knob (F) and the Rear Grille Mounting Nut (G). Place the Rear Grille (H)
onto theMotor Housing by making sure the 3 holes of the Rear Grille fit over the 3 bumps on the Motor Housing. Tighten the Rear Grille Mounting Nut CLOCKWISE. (Fig. 6)
Fig. 4
E
F
Fig. 5
Fig. 6 |
H |
G |