Eureka AS3100 manual How to replace brush roll or belt

Page 12

How to replace brush roll or belt

1

Remove 4 screws from brush roll cover. Lift off cover using rear tabs.

2

Use a Phillips screwdriver to remove 2 screws.

3

Pull up white latch to release the belt assembly and lift straight out.

4

5

6

Remove belt from motor shaft and brush roll.

Replace belt around motor shaft.

Insert left end of brush roll first. Loop new belt around right end of brush roll and insert right end cap into base.

7

8

	Replace the white latch assembly		Reinstall 2 screws.

back into position.

12Eureka Customer Service HELPLINE 1-800-282-2886

9

Replace brush roll cover and 4 screws.

www.eureka.com

Image 12

Contents Thank you for purchasing your new Eureka vacuum Where to find important vacuum information ContentsImportant Safeguards What comes in the carton OW EHow to assemble your vacuum cleaner Front View BackHow to identify parts of your vacuum cleaner Some modelsFilter maintenance instructions Dust cup Empty after each useHow to use your vacuum cleaner Empty dust cup after every useHow to use accessories Dusting brushCr vice tool Turbo nozzleHow to clear a blockage Make sure vacuum is turned off and power cord is unpluggedHow to maintain turbo nozzle How to maintain brush rollHow to clean brush roll How to replace brush roll or belt Problem Solution Motor will not start Vacuum does not cleanCarpet or bare floor No suction atEureka limited warranty USA Mexico 55 CanadaEureka Customer Service Helpline