15 | 16 | 17 |
|
|
|
A
15Plug cord into electrical outlet. To turn cleaner ON, push
switch (A) toward front of cleaner. To turn cleaner OFF, push (A) toward back of cleaner.
Handle Positions
The handle of your cleaner has
16three positions; upright for storage and when using cleaning tools; operating position for gener- al operation on carpet and floors; low for reaching under low furniture. Step on handle release lever to lower handle.
Tr a n s p o rting cleaner
17To move your cleaner from room to room, put handle in
upright position, tilt cleaner back on rear wheels and push forward.
18 | 19 | 20 | C |
B
D
A
18The cleaner can also be moved by using carrying handle.
Carpet height adjustment
The cleaning of carpet and ru g s
19takes place at the nozzle (A).
When it is necessary to raise and lower the nozzle for various carpet pile heights, slide the nozzle control knob (B) to the desired setting.
20For ease in sliding knob, the handle should be in the upright
position (C).
The nozzle will not move into the adjusted position until the cleaner handle is lowered to the operating position (D).
21 | 22 |
HIGHBARE
FLOOR
For maximum cleaning perfor-
21mance, the following carpet height settings are recommended .
•Lowest setting: for all types of carpet
•Higher settings: for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance.
Note: If the cleaner is difficult to push, slide knob to the next higher setting.
Edge cleaning
22Special edge groomers are pro- vided on both sides of the nozzle
to remove dirt in carpet near base- boards and furniture. Guide either side of nozzle parallel to edge of carpet or furniture.
5