Campbell Hausfeld MXS3000 specifications Operation, Lamp

			MXS3000
Assembly (cont.)
Lamp
•	Make sure the power supply is not	1. Plug power	3. Plug other
	plugged into lamp switch outlet.
		supply cord	end of power
	Place lamp switch box up to free end
	of lamp cord. Connect flag terminals	into wall	supply cord
	from the lamp cord to the lamp	outlet	into back of
	switch terminals labeled “2”		switch
	together. The brown wire goes on		box
	the top (near the “2”), the blue wire
	goes directly beneath. Secure lamp
	switch box to the cabinet using two
	(2) 5/16 in. long bolts, nuts, and lock
	washers. Tighten securely.
Operation			2. Make
After the blast cabinet is completely			sure switch
assembled, follow these instructions
		Figure 4 –	is in the
before supplying air to the cabinet.
		Light switch	(O) OFF position
1.	Position cabinet on a table or	power supply
	workbench where you will be
	performing the work.	8. Make sure the material hose is	10. Put on a NIOSH/MSHA approved
2.	Connect air supply (max. 125 psi) to	securely attached to the smaller tube	respirator and eye protection.
	the fitting on the side of the	(and does not touch the larger tube)	11. Pour blast media into cabinet basin.
	cabinet (see Figure 3).	of the metal pick up (see Figure 5).
			Make sure the end material hose is
	Air supply fitting		completely covered.
		Small tube	You can create dust
		Larger tube	when abrasive media
			is poured into or drained from the blast
	Air hose		cabinet. Wear a mask and eye protection
			when draining the blasting media.
	and
	connection	Figure 5 – Material hose and metal	12. Place item to be cleaned inside
Figure 3 – Connect air supply		pick-up tube	cabinet.
			13. Close and latch door.
		9. Position the end of the pick up tube
3.	Check for air leaks. If any are found,
		in the middle of the cabinet where	14. If a vacuum is to be used to remove
	repair or add teflon tape if needed.	the blast media will be deepest. There	blast media dust:
4.	Plug the 12V power supply into a	are metal guides to help stabilize the	A.Remove air filter from back of
	110V wall outlet (see Figure 4).	pick-up tube (see Figure 6).	cabinet (this filter is for use when
5.	Making sure the switch is in the (O)		a vacuum is NOT used)
	OFF position, plug the other end of		B. Install a proper sized adapter on
	the 12V power supply cord into the		end of vacuum hose and insert
	light switch on the cabinet (see	Guides	into port on right hand side of
	Figure 4).		cabinet. If the right size adapter
6.	Check that the light works. It can		is not available, any sort of
			attachment method that
	be rotated to prevent the light
			provides decent seal will work.
	from shining directly into your
	eyes.		15. Place hands in gloves, aim blast gun
7.	Add a plastic window protector		at surface to be cleaned and pull
			trigger.
	(supplied) to the inside surface of
	the glass door.	Figure 6 – Pick-up tube and guides
			www.maxustools.com
		3