Black & Decker PHV1810 Troubleshooting, Problem Possible Cause Possible Solution, Accessories

Troubleshooting

Problem	Possible Cause	Possible Solution
• Unit will not start.	• Battery not charged.	• Check battery charging
• Battery will not charge.	• Charger not plugged in.	requirements.
		• Plug charger into a working
		outlet. Refer to “Important
		Charging Notes” for more details.
		• Check current at receptacle by
		plugging in a lamp or other appliance.
		• Check to see if receptacle is
		connected to a light switch which
		turns power off when you turn out
	• Surrounding air	the lights.
		• Move charger and tool to a
	temperature too hot or	surrounding air temperature
	too cold.	of above 40 degrees F(4.5°C) or
		below 105 degrees F (+40.5°C).

For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at

1-800-544-6986. Accessories

Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call:

1-800-544-6986.

WARNING: The use of any accessory not recommended for use with this tool could be hazardous.

BATTERY REMOVAL AND DISPOSAL

This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries. When the batteries no longer hold a charge, they should be removed from the Vac and recycled. They must not be incinerated or composted.

The batteries can be taken for disposal to a Black & Decker, Company-Owned or Authorized Service Center. Some local retailers are also participating in a national recycling program (see “RBRCTM Seal”). Call your local retailer for details. If you bring the batteries to a Black & Decker Company-Owned or Authorized Service Center, the Center will arrange to recycle old batteries. Or, contact your local municipality for proper disposal instructions in your city/town.

To remove the battery pack for disposal:

1.) First, before attempting to disassemble the product, turn it on and leave it on until the motor completely stops insuring a complete discharge of the batteries.

2.) Ensure nozzle is rotated out of storage position.

3.) Using a phillips screwdriver, remove the seven screws securing the two housing halves.

4.) Lift the housing cover away from the assembly.

5.) Remove the single screw which secures the motor assembly. (located at bottom of unit, adjacent to the bowl.

6.) Lift out the motor assembly.

7.) Remove the three screws in the cover and lift the cover off of the assembly exposing the batteries.

8.) Detach motor connections and lift motor away from assembly.

9.) Detach all lead connections and remove batteries from battery casing.

10.) Dispose of batteries as per recommended guidelines.

7