Black & Decker PHV1210 instruction manual Symbols, Double insulated Per minute

•Do not incinerate the appliance even if it is severely damaged. The batteries can explode in a fire.

•This appliance is intended for household use only and not for commercial or industrial use.

•Shock Hazard. To protect against risk of electrical shock, do not put unit or charging base in water or other liquid.

•Do not allow the cord to hang over the edge of a table or counter or touch hot surfaces. The unit should be placed or mounted away from sinks and hot surfaces.

•Plug the charger directly into an electrical outlet.

•Use the charger only in a standard electrical outlet (120V/60Hz).

•Unplug the charger from outlet before any routine cleaning or maintenance.

•This product includes rechargeable nickel cadmium batteries. Do not incinerate batteries as they will explode at high temperatures.

•Leaks from battery cells can occur under extreme conditions. If the liquid, which is a 20-35% solution of potassium hydroxide, gets on the skin (1) wash quickly with soap and water or (2) neutralize with a mild acid such as lemon juice or vinegar. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes. Seek medical attention.

•Do not look into the air vents when the unit is switched on, as sometimes

there is a possibility of small debris being discharged from the air vents, especially after cleaning / replacement of the filters as debris inside the unit can be disturbed.

SAVE THESE INSTRUCTIONS

Symbols

•The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V			volts	A		amperes
Hz			hertz	W		watts
min			minutes	no		alternating current
		.............	direct current			no load speed
			Class I Construction			earthing terminal
	.................				..................
			(grounded)		.................	safety alert symbol
	.................		Class II Construction	.../min or rpm		revolutions or reciprocation
			(double insulated)			per minute

•When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

			Minimum Gauge for Cord Sets
Volts			0-25	Total Length of Cord in Feet
120V				26-50	51-100	101-150
240V			(0-7,6m)	(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
			0-50	51-100	101-200	201-300
Ampere Rating			(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
				American Wire Gauge
More		Not more
Than	-	Than	18	16	16	14
0		6
6	-	10	18	16	14	12
10	-	12	16	16	14	12
12	-	16	14	12	Not Recommended

3