MV650SPH
ASSEMBLY INSTRUCTIONS
Your BILLY GOAT ® MV Vacuum was shipped in one carton, completely assembled except for the Hood/Upper Handle Assembly. Mounting hardware for the Hood/Upper Handle Assembly is temporarily installed on the lower handle and the Housing assembly.
READ all safety instructions before assembling unit.
TAKE CAUTION when removing the unit from the box since Hood/Upper Handle Assembly is attached to the unit by cables.
Remove unit from carton. Make sure the following items that have been packed with unit: Parts bag P/N 840187
Owner’s Manual, P/N 840099
Declaration of Conformity, P/N 840204
Honda Engine Manual
Warranty Card, P/N 400972
Hardware Bag
DISCONNECT spark plug wire before assembling unit.
1.Attach hood assembly to the housing then hold in place during the step 2.
NOTE: BE SURE ALL CABLES ARE ROUTED ON THE UNDERSIDE OF THE HOOD AND HOUSING.
2.Install item #170 center bolt first when aligned with a nut on the housing.
3.Attach rest of hood assembly to the housing using corresponding hardware.
NOTE: You will have to insert the bolt/washer from the inside by reaching through the hood.
1st
- Two 7/16” wrenches.
Part No 840099 | 10 | Form No 082206A |