Billy Goat MV650SPH owner manual Operator Controls, Starting

MV650SPH Self-Propelled Vacuum Owner’s Manual

OPERATOR CONTROLS

The operator’s position is at the rear of the machine between the handlebars. The operator should STAND in a position to allow both handlebars to be grasped firmly, which allows sufficient leverage to steer the machine. Operator’s controls are shown below.

3

4

6

1

5

2

	Operator Control Locations
1	Drive Clutch Lever	4	Throttle Control
2	Bag Latch	5	Drive Shifter Control
3	Pull Starter	6	Nozzle Door Adjuster

STARTING

CHECK engine oil level before operating machine.

1.Place equipment on a level, firm surface that is free of rocks or other debris.

2.Place throttle in START position.

Throttle

DO NOT START equipment without the debris bag in place.

Form No F082206A 13 Part No 840099