Desa PROPANE GAS LOG HEATER installation manual OWNER’S Operation and Installation Manual

Page 1

SPLIT OAK DESIGN

UNVENTED (VENT-FREE)

PROPANE GAS LOG HEATER

— Also Designed Certified as Vented Decorative Appliance —

This appliance may be installed in an aftermarket* manufactured (mobile) home,

where not prohibited by state or local codes.

* Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer

OWNER’S OPERATION AND INSTALLATION MANUAL

®

LO

PILOT

OFF

HI

24" Variably-Controlled Models

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your build- ing.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas sup- plier, call the fire department.

Installation and service must be per- formed by a qualified installer, service agency, or the gas supplier.

WARNING: Improper installation, adjust- ment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual for correct installa- tion and operational procedures. For assistance or additional information con- sult a qualified installer, service agency, or the gas supplier.

WARNING: This gas log set is for instal- lation in a masonry solid fuel burning fireplace, a U.L. listed manufactured solid fuel burning fireplace or an AGA design certified vent-free firebox listed for use with these gas log models.

WARNING: This is an unvented gas- fired heater. It uses air (oxygen) from the room in which it is installed. Provi- sions for adequate combustion and ven- tilation air must be provided. Refer to “Air for Combustion and Ventilation” section in this manual.

Save this manual for future reference.

Image 1 Contents
What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information 001 Safety Device Local Codes Unpacking Product FeaturesOperation Piezo Ignition SystemProviding Adequate Ventilation AIR for Combustion and VentilationUnusually Tight Construction Unconfined SpaceDetermining if You Have a Confined or Unconfined Space Determining AIR Flow for Heater LocationVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Check GAS Type InstallingHigh traffic areas Windy or drafty areas LOG Sizing Requirements Minimum Fireplace Clearance To Combustible MaterialsMinimum Wall and Ceiling Clearances see Figure Minimum Non Combustible Material Clearances If Using Mantel Floor Clearances Attaching Damper Clamp Installing Damper Clamp Accessory for Vented OperationInstallation Items Needed Installing Heater Base AssemblyAttaching Mounting Brackets to Heater Connecting to GAS SupplyExternal Regulator With Vent Pointing Down Checking GAS Connections Pressure Testing gas Supply Piping systemTest Pressures Equal To or Less Than 1/2 Psig Pressure Testing Heater Gas ConnectionsNotch Front Log #1R Grate Prongs Metal Grate Bar Installing LogsInstalling Rear Log #3 Installing Crossover Log #5 Operating Heater To Turn OFF GAS to Appliance Operating HeaterPilot Flame Pattern Inspecting BurnersFront Burner Flame Pattern Turn off heater and let cool before cleaning Cleaning and Maintenance Trouble ShootingODS/PILOT and Burners LogsTROUBLE- Shooting Cleaning and MainteRefer to Air for Com Statement at top Trouble ShootingService Hints Technical ServiceParts Under Warranty Replacement PartsParts Not Under Warranty Valve GA5010 AccessoriesHood GA6050 Hood GA6052Illustrated Parts Breakdown KEY Part Number Description QTY Parts List102318 102318 Keep this Warranty Warranty Information