CLEANING AND MAINTENANCE
TROUBLE-
SHOOTING
Note: All trouble- shooting items are listed in order of operation.
WARNING
WARNING ICON | G 001 |
Turn off heater and let cool before cleaning.
CAUTION
WARNING ICON | G 001 |
You must keep control areas, burners, and circulating air passage- ways of heater clean. Inspect these areas of heater before each use. Have heater inspected yearly by a qualified service person. Heater may need more frequent cleaning due to excessive lint from carpeting, bedding material, etc.
ODS/PILOT AND BURNERS
• Use a vacuum cleaner or small, soft bristled brush to clean.
LOGS
•If you remove logs for cleaning, refer to Installing Logs, page 19, to properly replace logs.
•Replace log(s) if broken or chipped
WARNING
WARNING ICON | G 001 |
Turn off and unplug heater and let cool before servicing. Only a qualified service person should service and repair heater.
CAUTION
WARNING ICON | G 001 |
Never use a wire, needle, or similar object to clean ODS/pilot. This can damage ODS/pilot unit.
OBSERVED | POSSIBLE |
|
| |
PROBLEM | CAUSE | REMEDY | ||
|
|
|
|
|
When ignitor button | 1. | Ignitor electrode not con- | 1. | Reconnect ignitor cable |
is pressed, there is no |
| nected to ignitor cable |
|
|
spark at ODS/pilot | 2. | Ignitor cable pinched or | 2. | Free ignitor cable if |
|
| wet |
| pinched by any metal or |
|
|
|
| tubing. Keep ignitor |
|
|
|
| cable dry |
| 3. | Piezo ignitor nut is loose | 3. | Tighten nut holding |
|
|
|
| piezo ignitor to base |
|
|
|
| panel of log set. Nut is |
|
|
|
| located behind base |
|
|
|
| panel. |
| 4. | Broken ignitor cable | 4. | Replace ignitor cable |
| 5. | Bad piezo ignitor | 5. | Replace piezo ignitor |
| 6. | Ignitor electrode broken | 6. | Replace piezo ignitor |
| 7. | Ignitor electrode posi- | 7. | Replace piezo ignitor |
|
| tioned wrong |
|
|
Continued 25
102318