Desa PROPANE GAS LOG HEATER Installing Logs, Notch Front Log #1R Grate Prongs Metal Grate Bar

Page 19

INSTALLING

Continued

INSTALLING LOGS

WARNING

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front logs (#1L and #1R) on top of the grate. Make sure the notches in the bottom of the logs fit over the grate prongs (see Figure 17). Push back of logs flush with metal grate bar.

	Front Log (#1L)
Notch	Front Log (#1R)
	Front Log (#1R)
Grate Prongs

Metal Grate Bar

Figure 17 - Installing Front Logs (#1L and #1R)

2.Rest bottom middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The pegs on the log must be on top (see Figure 18).

Peg	Bottom Middle Log (#2)
Groove	Peg
Groove
Metal Post

Groove

Grate

Metal Post

Figure 18 - Installing Bottom Middle Log (#2)

Continued 19

102318

Image 19

Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information 001 Piezo Ignition System Local Codes Unpacking Product FeaturesSafety Device OperationUnconfined Space AIR for Combustion and VentilationProviding Adequate Ventilation Unusually Tight ConstructionDetermining if You Have a Confined or Unconfined Space Determining AIR Flow for Heater LocationVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Check GAS Type InstallingHigh traffic areas Windy or drafty areas LOG Sizing Requirements Minimum Fireplace Clearance To Combustible MaterialsMinimum Wall and Ceiling Clearances see Figure Minimum Non Combustible Material Clearances If Using Mantel Floor Clearances Attaching Damper Clamp Installing Damper Clamp Accessory for Vented OperationInstallation Items Needed Installing Heater Base AssemblyAttaching Mounting Brackets to Heater Connecting to GAS SupplyExternal Regulator With Vent Pointing Down Checking GAS Connections Pressure Testing gas Supply Piping systemTest Pressures Equal To or Less Than 1/2 Psig Pressure Testing Heater Gas ConnectionsNotch Front Log #1R Grate Prongs Metal Grate Bar Installing LogsInstalling Rear Log #3 Installing Crossover Log #5 Operating Heater To Turn OFF GAS to Appliance Operating HeaterPilot Flame Pattern Inspecting BurnersFront Burner Flame Pattern Logs Cleaning and Maintenance Trouble ShootingTurn off heater and let cool before cleaning ODS/PILOT and BurnersTROUBLE- Shooting Cleaning and MainteRefer to Air for Com Statement at top Trouble ShootingService Hints Technical ServiceParts Under Warranty Replacement PartsParts Not Under Warranty Hood GA6052 AccessoriesValve GA5010 Hood GA6050Illustrated Parts Breakdown KEY Part Number Description QTY Parts List102318 102318 Keep this Warranty Warranty Information