Linear AUH-S, AUJ-S owner manual Door Edge Installation Illustra tion

Page 13

Note:

edge

Door Edge Installation Illustration

CAUTION

TO AVOID DAMAGE TO DOOR AND

OPERATOR ENSURE ALL DOOR LOCKS ARE

DISABLED.

USE AN INTERLOCK SWITCH IF A LOCK IS

REQUIRED TO RETAIN FUNCTIONALTY.

9. See Figure 9 for

connecting the photoelectric device to the operator. See Page 17 for proper setting of the selector switches. These switches

must be properly set and an approved photoelectric device or approved door edge device connected to the operator to obtain B2 Mode of Operation, Momentary Contact to Close.

Image 13

Contents AUJ-S & AUH-S Table of Contents Standard Features Product FeaturesComponent Identification PreparationComponent Identification Listing Read and Follow ALL Installation InstructionsChain Coupling Mounting Installation InstructionsDirect Coupling Mounting Operator Mounting Positions Operator Dimensions Model AUH-S Operator Dimensions Model AUJ-S Limit Assembly Observe local electrical codes when wiring the operator Installation Instructions Electrical WiringDoor Edge Installation Illustra tion Door Edge and Photoelectric Wiring Turning on the Power to the Operator Single Button Station / Interlock Field WiringRead and Follow ALL Instructions Operation & Adjustment InstructionsSettable Switches Location TS Operation Setup ModesMid-Stop Limit Setup Brake AdjustmentAdjustments Operation & Adjustment Instructions Clutch AdjustmentOperation & Adjustment Instructions Maintenance Operation & Adjustment Instructions TestingTransformer Load Wiring DIAGRAM/SCHEMATIC Single PhaseConnect only one Approved entrapment Wiring DIAGRAM/SCHEMATIC Three PhasePart# Description Parts IdentificationSpecifications