Linear AUJ-S, AUH-S Read and Follow ALL Instructions, Operation & Adjustment Instructions

Page 16

16

 

OPERATION & ADJUSTMENT INSTRUCTIONS

 

 

 

 

 

IMPORTANT SAFETY INSTRUCTIONS FOR OWNER

WARNING

TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:

READ AND FOLLOW ALL INSTRUCTIONS!

Understand all of the operating features of your door control system at the time of its installation. Your installing dealer will demonstrate them for you.

NEVER let children operate or play with door controls. Keep the Remote Control (where provided) away from children.

Personnel should keep away from a door in motion and keep the moving door in sight until the door is completely closed or opened. NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR.

TEST THE DOOR OPENER’S SAFETY FEATURES AT LEAST ONCE A MONTH. After adjusting either the force setting or the limit of travel, ALWAYS RETEST the Operator’s safety features. Failure to ADJUST THE OPERATOR PROPERLY may cause SEVERE INJURY OR DEATH.

DO NOT over adjust the force setting to compensate for a poorly working door.

If possible, USE THE MANUAL RELEASE only when the door is closed. Use caution when using this release when the door is open. WEAK OR BROKEN SPRINGS MAY ALLOW THE DOOR TO CLOSE RAPIDLY, CAUSING SEVERE INJURY OR DEATH.

KEEP THE GARAGE DOOR PROPERLY BALANCED. See the door manufacturer’s owner's manual. An improperly balanced door COULD CAUSE SEVERE INJURY OR DEATH. Have a

TRAINED DOOR SYSTEMS TECHNICIAN MAKE REPAIRS TO CABLES, SPRING ASSEMBLIES AND OTHER HARDWARE.

Inspect and maintain your door system as described in this manual.

SAVE THESE INSTRUCTIONS

WARNING

AVOID ELECTROCUTION:

DO NOT ROUTE LOW VOLTAGE WIRES IN

SAME CONDUIT AS HIGH VOLTAGE

WIRES. FOLLOW ALL LOCAL

ELECTRICAL CODES OR THE NATIONAL

ELECTRICAL CODE.

WARNING

FAILURE TO TEST REVERSING

SYSTEM COULD RESULT IN DEATH OR SERIOUS INJURY. TEST THIS SYSTEM ONCE A MONTH.

Image 16
Contents AUJ-S & AUH-S Table of Contents Product Features Standard FeaturesPreparation Component IdentificationRead and Follow ALL Installation Instructions Component Identification ListingInstallation Instructions Chain Coupling MountingDirect Coupling Mounting Operator Mounting Positions Operator Dimensions Model AUH-S Operator Dimensions Model AUJ-S Limit Assembly Installation Instructions Electrical Wiring Observe local electrical codes when wiring the operatorDoor Edge Installation Illustra tion Door Edge and Photoelectric Wiring Single Button Station / Interlock Field Wiring Turning on the Power to the OperatorOperation & Adjustment Instructions Read and Follow ALL InstructionsSettable Switches Location Setup Modes TS OperationBrake Adjustment Mid-Stop Limit SetupOperation & Adjustment Instructions Clutch Adjustment AdjustmentsOperation & Adjustment Instructions Operation & Adjustment Instructions Testing MaintenanceWiring DIAGRAM/SCHEMATIC Single Phase Transformer LoadWiring DIAGRAM/SCHEMATIC Three Phase Connect only one Approved entrapmentParts Identification Part# DescriptionSpecifications