Installation of the Super Station

D:AUXILIARY EQUIPMENT

Setting The Coding Switches: When setting the Coding Switches THE FACTORY PRE-SET CODES MUST BE CHANGED TO PREVENT UNAUTHORIZED OPERATION. Transmitter and Receiver codes must be set IDENTICALLY. If just one Code Switch is mismatched, the Radio Controls will not function.

NOTE: For security reasons, it is advisable NOT to set all the switches in the same position.

Mounting The Receiver: After setting the Coding Switches, mount the Receiver on the rear panel of the Opener by connecting it to Terminals 1, 2 and 3. A small Plastic Pin is provided to secure the other end of the Receiver to the panel. For proper operation, the Antenna Wire should be POINTED STRAIGHT DOWN toward the floor.

104386

108386	After installing				the	Radio
	Controls, check their operation

	by moving			approximately 35
	FT away from the garage door
	and	pressing		the	Transmitter
PLASTIC	Button.		Operation			at	this
	distance should be reliable.
PIN
	If	the	Transmitter			doesn't
	activate		door	operation,			check
POINT ANTENNA	that all Coding Switches are set
STRAIGHT DOWN	identically.			If the	operational
	distance		is	inadequate,			try

moving the position of the Transmitter in the car. If the distance is still inadequate, try bending the Antenna Wire to a different angle. If the distance is still inadequate,

replace the Battery with a standard 9-Volt
“transistor radio” Battery (NEDA 1604). The	104388
	104388
Battery is located in the front compartment next to
the Coding Switches.
The Transmitter may be hand held if desired by
removing the Visor Clip from the rear of the Case
as illustrated. Place your finger in the loop at the
top of the visor, and your thumb on the top edge
of the Transmitter. Push down with your thumb
and pull up with your finger. The clip will release
and pull out easily.

CODING BLOCK: Transmitter and Receiver Coding Switches are contained in identical Coding Blocks, consisting of nine small switches, labeled 1 - 9, each of which can be set in any of three positions, labeled +, 0, -

WARNING

TO PREVENT THE RISK OF PERSONAL INJURY, DAMAGE TO DOOR OR PROPERTY, ONLY OPERATE DOOR CONTROLS WHEN DOOR IS IN CLEAR VIEW. KEEP REMOTE CONTROL AWAY FROM CHILDREN IN SECURE AREA.

The Super Station (Deluxe Wall Pushbutton Station) is an optional accessory designed to work with any 6000 Series Operator. Connection to any other operator may damage the operator and/or the Super Station. Only connect one operator to each Super Station. Do not connect more than one Super Station to an Operator.

STEP 1: After determining a suitable location, usually near the access door and at least 5 feet above the floor to prevent use by children, use the Super Station as a guide to mark the mounting holes. Drill holes for drywall anchors or screws. NOTE: Do not mount directly to masonry walls. Use backer board. The Super Station is also designed to be mounted directly to a standard single electrical box.

STEP 2: A length of 2-conductor, #22 gauge wire is required to connect the Super Station to the garage door operator. Strip approximately 6” of the wire jacket from one end and 1/2” of insulation from each wire. Carefully connect one wire to each of the two terminals indicated, noting which color is connected to which terminal. Tighten screws, being careful that no wires are allowed to touch any other terminal or any other conductive part of the circuit board. Do not overtighten the terminal screws.