Water Pump 19
Operator's Manual
NOTE
The throttle cable remains assembled to the engine cover and the spark plug lead and grommet remain installed.
IMPORTANT
DO NOT use a metal scraper to remove dirt from the cylinder fins.
3.Use the brush to remove dirt from the cylinder fins.
4.Remove grass and leaves from the grid between the starter and fuel tank.
5.When installing the cover, be certain the tab of the metal deflector shield is in the slot of the cover.
exhaust system
Spark Arrestor Screen
Level 2.
Parts Required: Spark Arrestor Screen, Gasket
1. | Remove engine cover. See “Cleaning Cooling System” for step by |
|
| step instructions. |
|
2. | Place piston at Top Dead Center (TDC) to prevent carbon/dirt from |
|
| entering cylinder. |
|
3. | Remove screen cover (A), screen holder (B), gasket (C), and spark |
|
| ||
| arrestor screen (D) from muffler body. |
|
4. | Clean carbon deposits from screen (D) and muffler components. |
|
5. | Replace screen if it is cracked, plugged or has holes burned |
|
| through. |
|
6. | Install spark arrestor screen, gaskets, and cover. | D |
|
| |
|
|
|
C
B
A