Echo WP-1000 T1E manual Removing Pump from Storage

Page 26

26

7.A. Allow engine to cool then remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

B.Plug the recoil starter handle 2-3 times to distribute the oil inside the engine.

C.Observe the piston location through the spark plug hole. Pull the starter handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

9.Using garden hose, run clear water through the pump, hoses and strainer.

10. Remove prime port plug and fill the pump housing with 50/50 solution of water and antifreeze.

11. Disconnect suction and discharge hoses.

12. Place a suitable cover over pump.

Removing Pump from Storage

1.Remove spark plug. Cover spark plug hole with clean rag.

2.Pull starter handle several full strokes to remove oil from cylinder.

3.Check spark plug gap; install plug. Connect spark plug cable.

4.Check that guards and shields are fastened in place.

5.Fill fuel tank with fresh fuel mix. (See Fuel sec- tion)

6.Install suction and discharge hoses making sure the connections are air tight.

7.Be sure to reinstall pump drain plug securely and prime the pump before starting.

8.Install prime port plug securely.

Image 26

Contents Water Pump Operators manual Table of ContentsIntroduction Safety Manual Safety Symbols and Important Information Water Pump Operators ManualTypical pump applications International symbolsPersonal condition and safety equipment Eye Protection Physical ConditionProper Clothing Hand ProtectionEmission Control exhaust & evaporative EPA 2010 and Later and/or C.A.R.B. TierEquipment Hot Decal near muffler DescriptionPage Contents Assembly suction hoseDischarge hose Garden HoseFuel Fuel RequirementsOperation Handling Fuel Mixing InstructionsPriming the pump Starting cold engine Cold weather operation Starting warm engineStopping engine Maintenace intervals MaintenanceSkill levels Air filter Fuel filterSpark plug Cooling systemSpark Arrestor Screen Exhaust systemExhaust Port Cleaning High Altitude Operation Carburetor adjustmentEngine Break-In Emission models with limiter capsFine Tuning Requires Accurate Tachometer Idle Speed AdjustmentBasic Setting Non Emissions Models Without Limiter CapsPump casing Troubleshooting Engine Problem Troubleshooting ChartStorage Troubleshooting pump endLong Term Storage over 30 days Removing Pump from Storage Specifications Water Pump Operator s ManualWarranty Statements Exceptions99922201032 11/18/2011 Page Water Pump Operators Manual Servicing Information parts/serial number ServiceWarranty registration Additional or replacement manuals Echo consumer product support