6
equipment
Before operation a complete check of the unit must be performed;
•Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
•Inspect guards and shield for damage and ensure that they are securely in place. Replace if they are damaged or miss- ing.
•Do not operate the pump without an air filter. Rapid engine wear will result.
•Ventilating openings such as crankcase ducts, engine cover, air filter and muffler exhaust outlet must be cleaned peri- odically and kept free of debris to ensure proper operation and adequate cooling of the engine and pump.
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings.
•ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
•DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
•NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
WARNINg
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found, do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an authorized servicing dealer before using.
Emission Control (exhaust & evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM (engine modification) and, if the second to last character of the Engine Family on the Emission Control Information label (sample below) is “C”, “K”, or “T”, the emission control system is EM and TWC
An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by engine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine
emissions output meets applicable emissions regulations, provided that approved maintenance procedures are fol- lowed as listed in the Maintenance Section of this manual.