Operating The Carpet Shampooer/Extractor
Power
Switch
0 = Off
( I = On )
NOTE: The nap of the carpeting and the amount and type of soil may require less or more cleaning solution be applied to achieve desired cleaning levels.
D.Push power switch on, which is located on the back side of the unit.
E.Pull up and hold the solution release trigger and apply two spraying strokes by moving the carpet shampooer/ extractor forward and then backward at a moderate pace two times. As the nozzle moves over the carpet, the cleaning solution is sprayed onto the carpet. At the same time the nozzle picks up the dirty water and places it in the recovery tank. It is important to move the carpet shampooer/extractor in a steady motion over any surface.
F.Release the trigger to stop the solution flow. Avoid over- soaking.
G.Move the carpet shampooer/extractor over the carpet several more times without engaging the trigger. Repeat this process until little or no water is visibly traveling under the clear suction shield. This removes excess water and helps the carpet dry faster.
H.Repeat steps E, F, and G on heavily soiled areas.
Transporting the Carpet Shampooer/Extractor
When moving the carpet shampooer/extractor from one location to another, always make sure the recovery and clean water solution tanks are completely empty. Then tilt the unit slightly backward and roll on rear wheels or use the carpet shampooer/extractor’s carrying handle for transporting up and down stairs.
11