Level II Programming

Programming Guide

The Level II programming has been programmed by the manufacturer to the settings in Table 6. The changing of preset values can be done at this time. Refer to Level II programming parameters in Table 6 for options.

Note: It is not recommended that homeowners change these values without checking with local water-treatment professional for details. Incorrect programming can cause system malfunction and the possible need for a field service call to reprogram the system. System programming is not covered under warranty.

To access Level II programming, simultaneously hold down the up [#] and down [$] arrows. This will allow you to enter Level II settings P6 through P19. (See Table 6.)

Level II Programming

Parameters

Level II Programming Parameters

Parameter	Description	Range	Minimum	Units of		Notes
			Increments	Measure

P6	Refill controller	1–99	1	gpm	.35 gpm, both models

P7	Brine draw value	1–99	1	Minutes	15, both models

P8	Not used	n/a	n/a	n/a	n/a

P9	Backwash time	3–30	1	Minutes	Skip this parameter to accept the default or enter a value

P10	Slow rinse time	8–125	1	Minutes	SA-HB-40-DB-CERT = 67
					SA-HB-48-DB-CERT = 80

P11	Fast rinse time	2–19	1	Minutes	Skip this parameter to accept the default or enter a value

P12	Units of measure	0–1	1		0	= U.S.
					1	= Metric
					Skip this parameter to accept the default (U.S.)

P13	Clock mode	0–1	1		0	= 12-hour clock
					1	= 24-hour clock
					Skip this parameter to accept the default (12-hour)

P14	Calendar override	0–30	1	days	0	= no calendar override
					Skip this parameter to accept the default (no override)

P15	Reserve type	0–3	1		0	= variable reserve

P16	Fixed reserve capacity	0–70	1	percent of	Description depends on the value entered for P15 (Reserve
	or initial average			capacity	type). Skip this parameter to accept the default.
	value

P17	Operation type	0–1	1		0	= Not used
					1	= 5-cycle counter current

P18	Salt / capacity change	0–1	1		0	= none
	lock out				1	= salt / capacity change locked out
					Skip this parameter to accept the default (no lock out)

P19	Factory defaults	DO NOT	1		Loads in factory default values. DO NOT CHANGE THIS
		CHANGE			PARAMETER.

Table 6: Level II programming parameters.

Hamilton Beach Owner’s Manual 15