Hamilton Beach SA-HB-40-DB-CERT manual Start-Up Rinsing Procedure, Start-up Rinsing Procedure

Start-up Rinsing Procedure

Start-Up Rinsing Procedure

(Bypass valve is optional)

1.With the plumbing, drain line, and overflow connections completed, slowly open the water supply allowing the lines to pressurize.

Note: The optional bypass should still be in bypass mode as shown in Figure 9.

Once the air clears and water begins to run to the drain, open the inlet valve (only) to the full open position and allow the water to run to the drain in purge for a minimum of 20 minutes. (See Figure 11.)

OutletInlet

Figure 9

2.With the control valve unplugged, manually advance the control valve by depressing the drive gear and rotating the main system gear to the purge position. (See Figure 10.)

Outlet Inlet

Figure 11

4.After the 20-minute purge cycle, manually advance the main gear to the backwash cycle and allow to run for a minimum of 10 minutes. (See Figure 12.)

Note: when advancing the main gear manually while under water pressure it is normal for the gear to encounter resistance as the valve chambers depressurize. If resistance occurs, pause five seconds to allow the valve to depressurize before advancing to the next step.

Figure 10

3.Slowly open the inlet valve (only) on the bypass valve allowing the system to pressurize. It is normal to hear air blowing to the drain during this procedure.

Figure 12

10 Hamilton Beach Owner’s Manual