Delta RP61611s, T17T085, T17T485, T17T285 manual 13 / 14 Series Installation, Cartridge Installation

1 Cartridge Installation

A.

4

5

3

2

1

13 / 14 Series Installation

B.

2	3
4

1

4

Turn off water supplies. Remove cover (1), bonnet nut (2) and test cap (3) from the body. If this is not a thin wall mounting, the entire plasterguard (4) may be removed. If screen (5) is in place, remove before installing cartridge.

Rotate the cartridge (1) so the words “hot side” (2) appear on the left. Insert cartridge into valve body as shown. Make sure the cartridge tubes and O-rings (3) are properly seated in holes at the base of the body. Ensure the keys on the body are fully engaged with the slots in the body (4).

Back to back Installation

Normal Installation (changes not required)

Reverse

Installation

Cold

Hot

For back to back or reverse installations (hot on right and cold on left) insert the cartridge with the “hot side” on the right. If you are not making a reverse or back to back installation skip this step and continue with step 1C.

C.

1

Slide bonnet nut (1) over the cartridge and thread onto the body. Hand tighten securely.

3