Vac Assembly
1.Line up front (label) of power assembly with Vacuum port located on the front of the drum.
NOTE: Power assembly must be aligned with drum for proper attachment.
2.Place power assembly on top of drum.
3.Be sure power assembly completely covers the top of the drum so leakage does not occur. Notch on power assembly must fit into slot on drum.
Power Head
Y
/ Power
Head
Assembly
Notch
lure
Port
4.Push clown on top of handles to cause flexible locking tabs to hook onto the drum lip,
5.Make sure that the locking tabs are snapped into place to prevent the lid from coming off (see detail below).
6.To remove the power assembly, reverse above directions.
Flexible Locking
Tab Pulled Out
Flexible
Locking
Head
Assembly
Push Down
and Pull Out
Locking Tab (located under latch)
Cord Wrap
The Wet/Dry Vac has a convenient cord
wrap area designed on the rear of the
Vac. Simply, wrap the power cord around
the push/pull handle, then snap the connector on the plug to a wrap of the cord, The cord is now wrapped for
storage.
Cord Wrap
Push/
Pull
Handle
Insert Hose
Insert the hose locking end of the
hose should snap into place. To remove the hose from the Vac, press the release button in the hose assembly and pull the hose out of the Vac inlet, as shown.