Vacuuming Dry Materials, Vacuuming Liquids

Vacuuming Dry Materials

1.The filter must always be in correct position to reduce the risk of leaks and possible damage to Vac.

2.When using your Vac to pick up very fine dust, it will be necessary for you to empty the drum and clean the filter at more frequent intervals to maintain peak Vac performance.

NOTE: A dry filter is necessary to pick up dry material. If you use your Vac to pick up dust when the filter is wet, the filter will clog quickly and be very difficult to clean.

The optional Craftsman HEPA Rated Material Filter, stock number 9-17912 will do a better job stopping very fine parti- cles than the 9-17816 filter.

Vacuuming Liquids

_, WARNING: Do not operate without filter cage and float, as they prevent liquid from entering the impeller and damaging the motor.

1.When picking up small amounts of liq- uid the filter may be left in place.

2.When picking up large amounts of liq- uid we recommend that the filter be removed. If the filter is not removed, it will become saturated and misting may appear in the exhaust.

3.After using the Vac to pick up liquids, the filter must be dried to reduce the risk of possible mildew and damage to the filter.

4.When the liquid in the drum reaches a predetermined level, the float mecha- nism will rise automatically to cut off air-flow. When this happens, turn off the Vac, unplug the power cord, and empty the drum. You will know that the float has risen because Vac airflow ceases and the motor noise will

become higher in pitch, due to increased motor speed.

IMPORTANT: To reduce the risk of dam- age to the Vac do not run motor with float in raised position.

Emptying the Drum

1.Remove the power assembly. Push

down and pull out the flexible locking tabs to release from drum.

2.While holding the locking tabs out, lift

the power assembly up and away from the drum.

3.Lay power assembly upside down on a clean area while emptying drum.

4.Dump the drum contents into the prop- er waste disposal container.

5.The 113.179675, 9-Gallon Wet/Dry Vac comes equipped with a drain for easy emptying of liquids. Simply unscrew the drain cap and lift the opposite side slightly to empty the drum.

_, WARNING: To reduce the risk of back injury or falls, do not lift a Vac heavy with liquid or debris. Scoop or drain enough contents out to make the Vac light enough to lift comfortably.

Blowing Feature

Your Vac features a blowing port. It can blow sawdust and other debris. Follow the

steps below to use your Vac as a blower.

1. Locate blowing port of your Vac.