Installation Instructions | UK |
Any electrical work required to install this appliance should be carried out by a quali fied electrician or competent person.
Any plumbing work required to install this appliance should be carried out by a quali fied plumber or competent person.
•The dishwasher is delivered ready for connection, i.e. with power supply cable, drain hose and inlet hose with fitted filter and seal.
•The installation should be carried out to connec tions provided in a neighboring cupboard (not di rectly behind the unit).
•The regulations of the local water and electricity companies must be complied with.
Water Supply Connections
86 - 91 cm
•The dishwasher must be plumbed into a cold water supply.
•The water pressure must be within the limits given in the technical specifications. Your local Water Au thority will advise you on the average mains pres sure in your area.
•A
•The inlet hose has a filter to remove any impurities from the water supply and a rubber seal. When fit ting ensure that the filter and seal are correctly po sitioned.
No water must escape from the fitting after the
Water outlet hose connection
•Ensure the drain hose is not bent or squashed as the could prevent or slow down the discharge of water.
•The outlet hose should be connected to a water outlet provided in a neighboring cupboard (not di rectly behind the unit).
•The dishwasher is fitted with a device to prevent the back flow of water, which allows the installation height of the unit to be above the outlet height.
•The highest point of the drain hose should never ex ceed the unit height.
600
510
546
762
550
570
574
759
AEG | 153 0409 20 / 09.99 |