Prior to Using for the First Time

Carry out the following steps before using your dish washer for the first time.

Filling with Rinse Aid

Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, spot and streak free drying.

AIf the rinse aid display light is lit on the control panel, open the dispenser by turning the sealing cap to the left.

BFill with rinse aid up to the "max" mark. Do not ex ceed the maximum container mark of 150 ml.

-Close the dispenser.

-Remove any spillage to prevent foaming.

The rinse aid display light on the control panel will go out.

Setting the rinse aid dosage

According to the finish and drying results obtained, the rinse aid dosage can be adjusted. Position 1 minimum dosage, position 6 maximum dosage.

The factory setting is level 3.

Gradually increase the dosage if there are drops of wa ter or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes.

Filling the salt dispenser

Warning! Only use special salt for dishwashers. Other types of salt (e.g., cooking salt) often contain water-insoluble components which can block the water softener and may render

it unserviceable.

Salt and detergent packages often look very similar. Detergent accidentally poured into the salt dispenser will damage the water softener. Each time you fill with special salt, ensure that you are really holding a salt package in your hand.

Fill with salt as follows:

AOpen the cap of the salt dispenser.

BFill the dispenser with water