CFill with 1 kg of special salt. As a result, approx. 1 litre of water will be displaced.
-Remove salt from around the opening of the dis penser.
-Close the salt dispenser by turning the cap until the stop is reached.
-Immediately run the
Never fill the salt dispenser with rinse aid or detergent!
The salt display will go out after 1 or 2 rinse cycles.
Do not remove the water feed valve, and do not fill with detergent for any reason.
Setting the Water Softener
The dishwasher is equipped with a water softener de signed to remove minerals and salts from the water supply, which would have a detrimental or adverse ef fect on the operation of the appliance.
The higher the content of these salts, the harder your water is.
The softener should be adjusted according to the hard ness of the water in your area. Your local Water author ity can advise you on the hardness of the water in your area.
Adjust the dosage as follows:
Turn the setting button using a coin or a screwdriver until the arrow on the knob points to the desired num ber.
The arrow must point to a number and the po sition must be engaged positively.
Clarke | French degrees | PPM (Parts | Level | ||
degrees | (°TH) | per Million) | |||
| |||||
|
|
|
|
| |
0 | - 9 | 0 - 12,5 | 0 - 125 | 1 | |
|
|
|
| ||
9 - 18 | 12,5 - 25 | 125 - 250 | 2 | ||
|
|
|
|
| |
18 | - 26 | 25 - 37,5 | 250 - 375 | 3 | |
|
|
|
|
| |
26 | - 35 | 37,5 - 50 | 375 - 500 | 4 | |
|
|
|
| ||
> 35 | > 50 | > 500 | 5 | ||
|
|
|
|
| |
The first wash cycle
-When using for the first time, use the Intensive pro gram.
A
B
C
4
3
5
2
1
8