Electrolux 50877 user manual Daily use, Adjusting the dosage of rinse aid

Page 14

14Daily use

2.Add the rinse aid in the container. The

maximum level for filling is indicated by "max".

The dispenser holds about 110 ml of rinse aid, which is sufficient for be- tween 16 and 40 dishwashing cycles, depending upon the dosage setting.

3. Ensure that the lid is closed after every refill.

Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.

Adjusting the dosage of rinse aid

According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1= minimum dosage, position 6= maxi- mum dosage).

The dose is factory set in position 4.

Increase the dose if there are drops of water or lime spots on the dishes after washing.

Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades.

Daily use

Check if it's necessary to refill with dishwasher salt or rinse aid.

Load cutlery and dishes into the dishwasher.

Image 14
Contents Favorit Dear Customer Contents Installation instructions Operating instructions Safety information Correct useInstallation General safetyChild safety Product description Indicator lights Control panelFunction buttons Setting modeDigital display Digital display indicatesSet the water softener To cancel a set programme or a programme in progressFirst use Setting manually Set the water softenerExamples Setting electronicallyUse of dishwasher salt To fillUse of rinse aid Only use branded rinse aid for dishwashersAdjusting the dosage of rinse aid Daily useLoad cutlery and dishes Lower basket Cutlery basket Upper basket Adjusting the height of the upper basket Raising / lowering the upper basketUse of detergent Fill with detergentMulti-tab function Detergent tabletsActivation/deactivation of the Multitab function Activation/deactivation of the rinse aid dispenserWashing programmes Select and start a washing programme Interrupt a washing programme in progress Setting and starting the programme with delay startCancelling the delay start and / or a washing programme End of the washing programmeUnloading the dishwasher Care and cleaningCleaning the filters Clean all filters thoroughly under run- ning water Internal cleaning Cleaning the spray armsExternal cleaning Frost precautionsWhat to do if… What to do if… Remove the water inlet and discharge hosesProgramme does not start Technical data Technical dataHints for test institutes Example loading arrangements Proceed as follows InstallationFitting under a counter kitchen worktop or sink Locknut must be correctly fitted to avoid water leaks LevellingWater supply connections Water outlet hose connection Electrical connection Sink trap spigot, the entire plastic memEnvironment concerns Packaging materialPage 117970660-12022008