Electrolux 50877 user manual Installation, Fitting under a counter kitchen worktop or sink

Page 34

34Installation

Installation instructions

Installation

WARNING!

Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.

Remove all packaging before positioning the machine.

If possible, position the machine next to a water tap and a drain.

Fitting under a counter (kitchen worktop or sink)

By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

1. Remove the machine's worktop by unscrewing the two rear retaining screws, pull the worktop from the back of the machine and slide out the front slots, lifting the worktop.

2.Insert the machine after adjusting the levelling with the adjustable feet.

Image 34

Contents Favorit Dear Customer Contents Installation instructions Operating instructions Safety information Correct useChild safety General safetyInstallation Product description Indicator lights Control panelFunction buttons Setting modeDigital display Digital display indicatesFirst use To cancel a set programme or a programme in progressSet the water softener Setting manually Set the water softenerExamples Setting electronicallyUse of dishwasher salt To fillUse of rinse aid Only use branded rinse aid for dishwashersAdjusting the dosage of rinse aid Daily useLoad cutlery and dishes Lower basket Cutlery basket Upper basket Adjusting the height of the upper basket Raising / lowering the upper basketUse of detergent Fill with detergentMulti-tab function Detergent tabletsActivation/deactivation of the Multitab function Activation/deactivation of the rinse aid dispenserWashing programmes Select and start a washing programme Interrupt a washing programme in progress Setting and starting the programme with delay startCancelling the delay start and / or a washing programme End of the washing programmeCleaning the filters Care and cleaningUnloading the dishwasher Clean all filters thoroughly under run- ning water Internal cleaning Cleaning the spray armsExternal cleaning Frost precautionsWhat to do if… What to do if… Remove the water inlet and discharge hosesProgramme does not start Technical data Technical dataHints for test institutes Example loading arrangements Fitting under a counter kitchen worktop or sink InstallationProceed as follows Water supply connections LevellingLocknut must be correctly fitted to avoid water leaks Water outlet hose connection Electrical connection Sink trap spigot, the entire plastic memEnvironment concerns Packaging materialPage 117970660-12022008