Electrolux 40250 i What to do, if, there are problems with the operation of the dish- washer

Operating Instructions

What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

...there are problems with the operation of the dish- washer.

Symptom	Possible Cause	Solution
The drain pump in the
dishwasher runs con-	The anti-flood system has	Close the tap, then unplug
tinuously - even with		from the mains and contact
	been triggered.
the appliance switched		AEG Service Force.
off.
	The door of the dishwasher is	Shut the door.
	not closed properly.
The programme does	Mains plug is not plugged in.	Insert mains plug.
	House fuse in defective.	Replace fuse.
not start.
		If the dishes are to be
	A delay start is selected.	washed immediately, set the
		delay start to 0 hours
	The washing compartment is	Only wash cutlery and dishes
	made of corrosion-resistant	that are suitable for dish-
	stainless steel. Rust spots in	washer use.
	the washing compartment
Rust spots are visible in	are from particles from out-
the washing compart-	side the appliance (rust par-
ment.	ticles from the water pipe,	Close the lid of the special
	from pans, cutlery, etc.).
		salt container securely.
	Remove such spots with a
	commercially available stain-
	less steel cleaner.
There is a whistling	The whistling is not a cause	Use a different brand of
noise during washing.	for concern.	detergent.

24