Electrolux 40250 i Electrical Connection, Changing a fuse, measures not be observed, Blue, Brown

Page 34

Electrical Connection

Installation and Connection Instructions

Electrical Connection

	Any electrical work required to install this appliance should be car-
	ried out by a qualified electrician or competent person.
1	WARNING - This appliance must be earthed.
	The manufacturer declines any responsibility should these safety

measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are coloured in accordance with the following code.

Green

& Yellow

Blue

Brown

Green and Yellow : Earth

Blue	: Neutral
Brown	: Live

Cord Clamp

•The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

•The wire coloured blue must be connected to the terminal “N“ or col- oured black.

•The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

•Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.

34

Image 34

Contents ÖKOFAVORIT 40250 Dishwasher User InstructionsDear customer Bio Wash Programmes and Concentrated Detergents CONTENTSContents Changing/Interrupting the Wash ProgrammeInstallation and Connection Instructions Child Safety 1 Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material 2 Disposal2 Economical and Ecological Dishwashing Disposal of Old AppliancesSpray Arms Water Hardness Switch Appliance Features and Control PanelRubber Seal for Connecting the Water Feed to the Upper Spray Arm Container for DetergentPrior to using for the first time Control PanelAdjust the Water Softener Filling with Salt for the Water Softener Fill with dishwasher saltFilling with Rinse Aid Fill with rinse aidAdjusting Rinse Aid Dosing In Daily Use Loading Cutlery and DishesLoading Cutlery 0 1. Slightly lift the right plate insert Loading Pans, Frying Pans and Large PlatesLoad large and heavily soiled dishes in the lower rack 2. Fold the plate insert to the leftThe cup racks can be folded up out of the way for tall items Loading Cups, Glasses and Coffee Servicesoffset from each other and water can reach all items Lay or hang wine, champagne, andFilling with Detergent Fill with DetergentConventional, alkaline detergents with caustic components Bio Wash Programmes and Concentrated DetergentsDetergent Recommendations Weak alkaline concentrated detergents with natural enzymesNORMAL Selecting the Wash Programme Programme TableChoose the most suitable wash programme with the aid of this table Programme SequenceChanging/Interrupting the Wash Programme Starting the Wash ProgrammeChanging the wash programme Emptying the Dishwasher Care and CleaningSwitching Off the Dishwasher washerThe dishwasher filter system com Cleaning the FilterThe filters should be checked and base of the washing compartmentthere are problems with the operation of the dish- washer What to do, ifThe dishes are wet and dull the wash result is unsatisfactoryThe dishes are still dirty There are dried water drops on the glasses and dishes73/23/EWG dated 19. 02. 1973 - Low Voltage Directive Technical DataThis appliance conforms with the following EU Directives 89/336/EWG dated 03. 05Bottom rack with cutlery basket Notes for Test InstitutesExample Loading Arrangement Upper rack lower and upper positions INSTALLATION AND CONNECTION INSTRUCTIONS Installing the DishwasherBuilt-In Dishwasher Dishwashers That Can Be IntegratedFree-Standing Appliances work surface must be re-mounted 3 The plinth on free-standing appliances is not adjustableDecor panel dimensions Height 590 mm Width 581 mm Clamp thickness max. 4 mmPermitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseExtension hoses Water drainDrain hose Sink outlet connectionLeak Prevention System appliance is automatically pumped outried out by a qualified electrician or competent person Electrical ConnectionChanging a fuse WARNING - This appliance must be earthedWater inlet ConnectionsTwo 45 or Straight Connections MainsGUARANTEE CONDITIONS Guarantee ConditionsPage Page 08705 929 SERVICE & SPARE PARTSCustomer Care AEG Hausgeräte GmbH Postfach D-90327 Nürnberg Copyright by AEG 822 945 464 - 00