Operating Instructions
4.Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml.
5.Close the lid and press until it locks
into place.
6. Wipe up any spilt rinse aid with a cloth. Otherwise too much foam will be formed during the wash.
| Adjusting Rinse Aid Dosing |
3 | As the dishes are washed rinse aid is released from the dispenser into |
| the wash water. The dose is factory set at 4, and can be adjusted from |
1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery.
0 1. Open the door of the dishwasher.
2.Press the rinse aid compartment release button with your finger.
3. Fully open the rinse aid compartment lid.
4. Set the dose level.
5. Close the lid and press until it locks into place.
6.If rinse aid has run out, wipe up with a cloth.
In Daily Use
•Check the salt and rinse aid levels.
•Load cutlery and dishes into the dishwasher
•Fill with dishwasher detergent
•Select a wash programme suitable for the cutlery and dishes
•Start the wash programme
13