Electrolux 50700 manual Unscrew the screws 1 from the elbows on the back side

Page 31

Installation and Connection Instructions

•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

–Unscrew the screws (1) from the elbows on the back side.

–Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear

(5).

•The dishwasher must also be screwed on tightly to the work surface or to the adjoining units. This is absolutely necessary so that its sta- bility is guaranteed according to VDE regulations.

1If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted.

3 The plinth on free-standing appliances is not adjustable.

Image 31

Contents Ökofavorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions General Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Control panel Prior to using for the first timeSalt Adjust the Water SoftenerHardness range of the water in your area Open the door, remove the lower rack Filling with Salt for the Water SoftenerFill with dishwasher salt Use dishwasher saltFill with rinse aid Filling with Rinse AidOugh rinsing, spot and streak free drying Age the applianceDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesLoading Cutlery Load large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans and Large PlatesLoading Cups, Glasses Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Lowering the Upper BasketFill with detergent Filling with DetergentDetergent Recommendations Bio Wash Programmes and Concentrated DetergentsSoiling Selecting the Wash Programme Programme TableChanging the wash programme Changing/Interrupting/CancellingStart the Wash Programme Wash ProgrammeChanging the delay start Setting or Changing the Delay Start TimerCancelling the wash programme Dishwasher is switched on againSwitching Off the Dishwasher Care and CleaningEmptying the Dishwasher Cleaning the Filter What to do, if Error messagesDishes are wet and dull There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyLower rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Upper basket Lower basket with cutlery basket Sample loading arrangementsFree-Standing Appliances Installing the DishwasherCannot be kinked or crushed Unscrew the screws 1 from the elbows on the back side Connect the inlet hose Connecting the DishwasherWater Connection Permitted water pressureWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions Page Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG