Electrolux 50700 manual Leak Prevention System, Appliance is automatically pumped out

Page 34

Installation and Connection Instructions

	Leak Prevention System
	For protection from damage due to water leaks, the dishwasher is
	equipped with a leak prevention system, the AQUA CONTROL SYSTEM.
	In the event of a fault, the drain pump switches on. By this means
	water can neither escape nor overflow. The remaining water in the
	appliance is automatically pumped out.
1	The AQUA CONTROL SYSTEM also works when the appliance is switched
	off – the appliance must however not be disconnected from the mains.

34

Image 34

Contents Ökofavorit Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Prior to using for the first time Control panelSalt Adjust the Water SoftenerHardness range of the water in your area Use dishwasher salt Filling with Salt for the Water SoftenerFill with dishwasher salt Open the door, remove the lower rackAge the appliance Filling with Rinse AidOugh rinsing, spot and streak free drying Fill with rinse aidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rackLoading Cups, Glasses Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Raising the Upper BasketFilling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Detergent RecommendationsSelecting the Wash Programme Programme Table SoilingWash Programme Changing/Interrupting/CancellingStart the Wash Programme Changing the wash programmeDishwasher is switched on again Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startSwitching Off the Dishwasher Care and CleaningEmptying the Dishwasher Cleaning the Filter Error messages What to do, ifDishes are still dirty There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are wet and dullLower rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket Lower basket with cutlery basketFree-Standing Appliances Installing the DishwasherCannot be kinked or crushed Unscrew the screws 1 from the elbows on the back side Permitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Page Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG