Electrolux 50700 manual What to do, if, Error messages

Page 26

Operating Instructions

What to do, if ...

Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.

...Error messages

If the programme indicator for the selected wash programme is flashing and fault code (1 or (2 is displayed on the multi-display, you can probably rectify the fault yourself.

After rectifying this fault, press the button for the wash programme that has been started. The wash programme continues. If the fault code is displayed again, contact customer service.

For all other faults, please contact customer service, stating the fault code.

Symptom

Possible Cause

Solution

Fault code (1 is dis-

Tap is blocked or furred with

Clean tap.

played on the multi-

lime-scale.

 

display.

The filter (where present) in

 

The programme indica-

Clean the filter in the

tor for the selected

the threaded hose fitting is

threaded hose fitting.

blocked.

wash programme is

 

 

 

flashing:

 

 

there is no water run-

The water inlet hose is not

Check hose installation.

ning into the dish-

correctly laid.

 

washer.

 

 

Fault code (2 is dis-

The sink outlet is blocked.

Clean the sink outlet.

played on the multi-

 

 

display.

 

 

The programme indica-

The water drain hose is not

Check hose installation.

tor for the selected

correctly laid.

wash programme is

 

 

 

flashing.

 

 

Fault code (3 is dis-

The leak prevention system

Close the tap and contact

played on the multi-

your local AEG Sevice Force

has been triggered.

display.

Centre.

 

 

 

 

26

Image 26
Contents Ökofavorit Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Prior to using for the first time Control panelHardness range of the water in your area Adjust the Water SoftenerSalt Use dishwasher salt Filling with Salt for the Water SoftenerFill with dishwasher salt Open the door, remove the lower rackAge the appliance Filling with Rinse AidOugh rinsing, spot and streak free drying Fill with rinse aidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rackLoading Cups, Glasses Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Raising the Upper BasketFilling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Detergent RecommendationsSelecting the Wash Programme Programme Table SoilingWash Programme Changing/Interrupting/CancellingStart the Wash Programme Changing the wash programmeDishwasher is switched on again Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startEmptying the Dishwasher Care and CleaningSwitching Off the Dishwasher Cleaning the Filter Error messages What to do, ifDishes are still dirty There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are wet and dullThere are dried water drops on the glasses and dishes Technical DataLower rinse aid dosing Sample loading arrangements Upper basket Lower basket with cutlery basketCannot be kinked or crushed Installing the DishwasherFree-Standing Appliances Unscrew the screws 1 from the elbows on the back side Permitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Page Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG