Electrolux 50700 manual Start the Wash Programme, Changing/Interrupting/Cancelling

Page 22

Operating Instructions

Start the Wash Programme

0 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate.

2.Open the tap fully.

3.Shut the door.

4.Press the ON/OFF button. The ON/OFF button indicator illuminates.

5.Press the programme button for the desired programme (see "Pro- gramme Table"). The programme indicator illuminates. The selected programme begins after around 6 seconds. The time remaining until the end of the programme is displayed on the multi-display, the time calculated is dependent on the load in the dish racks.

With automatic programme adjustment this residual time count can be stopped or corrected if necessary (load quantity, degree of dirtiness, etc.) using the dishwasher control.

3

If fault messages are displayed on the multi-display after the start of

 

the programme, please read the "What to do, if..." section.

 

Changing/Interrupting/Cancelling

 

the Wash Programme

3

Only change or interrupt a wash programme in progress if it is abso-

 

lutely necessary to do so.

 

Changing the wash programme

3

If you want to change the wash programme within 6 seconds of mak-

 

ing a programme selection, briefly press the button for the new wash

 

programme.

 

If you want to change the wash programme at a later point in time, use

 

the following procedure:

0 1. Press the button for the new wash programme and hold it pressed. The indicators for both programmes now flash.

2.After a few seconds only the indicator for the new programme flashes. Release the programme button, the new programme is now running.

Interrupting the wash programme by opening the door of the dishwasher

1Hot steam may escape from the appliance when opening the door. Open the door carefully.

22

Image 22
Contents Ökofavorit Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Prior to using for the first time Control panelSalt Adjust the Water SoftenerHardness range of the water in your area Use dishwasher salt Filling with Salt for the Water SoftenerFill with dishwasher salt Open the door, remove the lower rackAge the appliance Filling with Rinse AidOugh rinsing, spot and streak free drying Fill with rinse aidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rackLoading Cups, Glasses Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Raising the Upper BasketFilling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Detergent RecommendationsSelecting the Wash Programme Programme Table SoilingWash Programme Changing/Interrupting/CancellingStart the Wash Programme Changing the wash programmeDishwasher is switched on again Setting or Changing the Delay Start TimerCancelling the wash programme Changing the delay startSwitching Off the Dishwasher Care and CleaningEmptying the Dishwasher Cleaning the Filter Error messages What to do, ifDishes are still dirty There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are wet and dullLower rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket Lower basket with cutlery basketFree-Standing Appliances Installing the DishwasherCannot be kinked or crushed Unscrew the screws 1 from the elbows on the back side Permitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Page Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG