Operating Instructions
...there are problems with the operation of the dish- washer.
Symptom | Possible Cause | Solution | |
| The door of the dishwasher is | Shut the door. | |
| not closed properly. |
| |
The programme does | Mains plug is not plugged in. | Insert mains plug. | |
House fuse is defective. | Replace fuse. | ||
not start. | |||
|
| If the dishes are to be | |
| A start delay is selected. | washed immediately, set the | |
|
| start delay to 0 hours | |
| The washing compartment is | Only wash cutlery and dishes | |
| made from | that are suitable for dish- | |
| steel. Rust spots in the wash- | washer use. | |
| ing compartment are due to |
| |
Rust spots are visible in | rust particles from external |
| |
the washing compart- | sources (rust particles from |
| |
ment. | water pipes, pans, cutlery, | Close the lid of the special | |
| etc.). Remove such spots with | ||
| salt container securely. | ||
| one of the stainless steel |
| |
| cleaners that are generally |
| |
| available on the market. |
| |
There is a whistling | The whistling is not a cause | Use a different brand of | |
noise during washing. | for concern. | detergent. | |
|
|
|
...the wash results are not satisfactory.
The dishes are still dirty.
–The wrong wash programme was selected.
–The dishes were loaded is such a way that the wash waster did not reach all items. The racks for the dishes must not be overloaded.
–The filter in the base of the washing compartment is dirty or incor- rectly positioned.
–Detergent was not used or too little was used.
–In the case of scale deposits on the dishes: The special salt container is empty or the water softener is incorrectly adjusted.
–The drain hose is incorrectly laid.
The dishes are wet and dull.
–Rinse aid was not used.
–The rinse aid container is empty.
27