Electrolux SIG 400 Connecting to GAS, Connection to the Electricity Supply

Page 45

S I G 4 0 0

4. CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be less that R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance. NOTE:

ONLY LIQUID SEALANTS TO BE USED WHEN INLET GAS PIPE IS FITTED TO SHUT OFF VALVE I.E.: DO NOT USE P.T.F.E. SEALANT TAPE. Check for gas soundness after connecting to the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig.3. Take into account that it must be possible to pull the appliance forward sufficiently. The hose must not get caught on the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.

50 100

850

Fig.3

700

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO 50 mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

250

450

All dimensions in mm

5. CONNECTION TO THE ELECTRICITY SUPPLY

WARNING: THIS APPLIANCE MUST BE EARTHED. DO NOT EARTH THIS APPLIANCE TO THE GAS SUPPLY PIPING.

This appliance must be connected to 220V-240V A.C. 50Hz supply. It is supplied with 2 metres of 5 amp 3 core cable incorporating a moulded 13 amp plug , fitted with a 3 amp fuse, which can be plugged directly into the nearest suitable socket. If this is not long enough, the supply cable can be replaced totally by a longer cable at least 0.75mm² nominal cross sectional area (24/0.2mm).

IF THE MOULDED PLUG IS CUT FROM THE CABLE

FOR ANY REASON, IT MUST BE DESTROYED OR

DISPOSED OF SAFELY, AS THE PROTRUDING

WIRES WILL BE AN ELECTRIC SHOCK HAZARD.

If any other type of plug is used it should incorporate a 5 amp fuse in either the plug or adapter or at the distribution board.

If the cable has to be threaded through small apertures inFig.4 cabinets etc., it may be disconnected from the appliance,

then re-connected to as shown in Fig.4.

DO NOT EXTEND THE CABLE USING PLASTIC OR CERAMIC CONNECTION TERMINAL BLOCKS AND/OR INSULATION TAPE.

ALL EXTERNAL WIRING BETWEEN THE APPLIANCE AND THE ELECTRICAL SUPPLY SHALL COMPLY WITH I.E.E. WIRING REGULATIONS.

45

Page 44 Page 46
Image 45
Page 44 Page 46
Contents SIG Introduction For your safetyContents Hotplate Lighting the cookerGrill/second oven GrillSecond oven Main oven To turn off any burnerMark you want Close the oven door Grill High settingHeat control Cooking positionsGeneral PreheatingPositioning food on the grid Grill pan is supplied with a removable handle Grill pan and handleHotplate Burner sizesHotplate control knobs turn Rapid Helpful hints Ovens Heat zonesOven shelves Baking trays and dishes Condensation RoastingOven cooking chart Main oven Mins. per ½kg 1lb and 25 mins 15 25 mins 30 40 minsRolls and buns 10 20 mins Base Medium Oven cooking chart Second ovenLamb Shelf on Medium Base Well DoneFruit pie shortcrust 25 35 mins Baked custard 50 60 mins To set the time of day Electronic timerTo use the minute minder Turn the selector knob to manual then turn to clockSetting the controls for automatic use Clock. Turn Setting knob Either directionAutomatic control How long will Turn the selector knob to Food take Cooked by? Switch off showsTo cook? Display What time do Turn the selector knob to You wantHints and tips for automatic cooking Slow cooking Food preparation slow cookingPlease note There is no slow cook on the second oven Do not cook casseroles over 3kg 6lb Thaw thoroughly before cookingLeft over food should be cooled quickly and refrigerated Cleaning the brass plated handles Where applicable Care and cleaning For your safetyWhen replacing hotplate burner parts Clean the grill frequently using hot soapy waterCrown to body Do not try to force the crown on to the body Main oven Main oven cleaning cycle Location Installing the cooker For your safetyMake sure that a stability bracket is fitted For further details seePositioning Cooker dimensionsCurtains behind the cooker Height to hotplate 900mm 920mmGeneral information For your safety Connecting to the electricity supplyMoving your cooker General information Check What is wrong and why?G 4 0 Problem 7 0 5 9 2 9 9 2 Service and spare partsCustomer Care Department Installation Instructions Technical Data Main Oven Important Safety RequirementsSecond Oven GeneralLocation of Appliance Parts Required Levelling the ApplianceFitting the Stability Bracket Connection to the Electricity Supply Connecting to GASPressure Testing Checking the GrillChecking the Hotplate Checking the Main Oven Controls Checking the Main OvenAutomatic Operation General Note Checking the Second OvenNI GO T4E0S0 SIG400 Contents Check List From the Electrolux Group. The worlds No choice Electrolux Household Appliances Limited
Top Page Image Contents