THINGS TO NOTE
This appliance is designed to be fitted in cabinets of the recommended dimensions as shown (Fig. 3), page 42.
If your cabinet interior dimension is between
The dimensions given provide adequate air circulation around the unit within the cabinet, ensuring compliance with BS
Enquiries regarding the installation of the cooker point if required should be made to your Regional Electricity Company to ensure compliance with their regulations.
The cooker socket switch should be outside the cabinet but within 2m of the appliance to make it accessible to switch off the appliance in case of an emergency.
To protect the hands wear gloves when lifting the oven into its housing.
Do not lift the appliance by the handles.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried out before the appliance is connected to the mains supply and
PREPARING CABINET FOR FITTING OF OVEN
Make sure the cabinet is the correct size for the appliance to be fitted (Ref. Fig. 3), page 42.
If the size is between
The cabinet must be stable and level by firmly securing it to the wall or floor. If necessary, make arrangements to ensure the shelf upon which the oven will rest is level.
When the appliance is installed ensure a minimum gap of 2mm is maintained between the trim on the bottom edge of the appliance and any corresponding door/ panel underneath.
41