Wolf WKGDX 126624, WKGX 126623 Door Adjustment, Door Catch Ball Adjustment Independent Doors

Page 24

FULL SIZE GAS CONVECTION OVENS - SERVICE PROCEDURES AND ADJUSTMENTS

DOOR ADJUSTMENT

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

1.Check the doors to make sure they have an equal gap between them and that the vertical edge of the door is parallel to the vertical door seal. If the doors are not positioned in this manner, adjust the doors as described.

2.Remove the top front cover.

3.Loosen the screws that secure the upper door bearings and related hardware, just enough to allow door movement.

4.Move the door until proper alignment is achieved then tighten the screws on the upper door bearing hardware.

5.Repeat step 3 and 4 on the opposite door, if necessary.

DOOR CATCH BALL

ADJUSTMENT

(INDEPENDENT DOORS)

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

1.Remove top front cover as outline under COVERS AND PANELS in REMOVAL AND REPLACEMENT OF PARTS.

2.Open the doors and inspect door strike for proper shape.

A.Replace if bent and adjust as outlined in this procedure.

3.Open and close the doors several times while observing the catch ball operation.

A.Replace if malfunctioning and adjust as outlined in this procedure.

NOTE: Shims may be required under the door strike, before the proper door tension adjustment can be set.

F32700 (February 2006)		Page 24 of 64

Image 24

Contents WKG Series Full Size GAS Convection Ovens Table of Contents Computer Control Models Only Installation Operation Cleaning Lubrication SpecificationsIntroduction ToolsCovers and Panels Top Front CoverBottom Front Cover Control PanelRemovable Components Procedure Control Panel ComponentsComponent Panel Components Temperature Probe WKGD/WKGDX GAS BurnerGAS Orifice GAS Solenoid ValveIgnition Control Module Spark Igniter Flame SenseBlower and Motor Oven Doors and Bearings Independent Doors Assembly Removal Oven Doors Simultaneous DoorsDoor Catch Ball Assembly Independent Doors DisassemblyDoor Window Door Switch High Limit Thermostat Interior LightsLamp Lamp Assembly Cooling FANService Procedures and Adjustments Solid State Temperature Control Calibration WKGD/WKGDXSolid State Temperature Mechanical Thermostat Calibration WKG/WKGXTemperature Probe Test WKGD/WKGDX Temperature Probe Test WKGD/WKGDXGAS Pressure Adjustment Temp F OhmsDoor Switch Adjustment Verification of Spark AT IgnitorBlower Adjustment Door Adjustment Door Catch Ball Adjustment Independent DoorsProcedure IntroductionOperation Setup Mode Computer Control WKGC/WKGCXComputer Control Calibration WKGC/WKGCX Probe TestSolid State Relay Test Function Switch S3 Door SwitchComponent Function Solid State Temperature Control Blower MotorMotor Speed Relay R1 Computer ControlTemperature Probe Mechanical Temperature ControlComponent Location Gas Valve Dual SolenoidWKG/WKGX Plug, Socket and Components Standard Controls WKGD/WKGDX Plug, Socket and Components Standard Controls Full Size GAS Convection Ovens Electrical Operation WKGC/WKGCX Plug, Socket and Components Roast & Hold Standard Sequence of Operation WKG, Wkgx With Roast & Hold Option Mechanical KX ThermostatNormal Roast Cycle Timer Cycle Normal Roast Cooking Roast and Hold CycleFull Size GAS Convection Ovens Electrical Operation Timer Cycle Roast & Hold Cooking State Temperature Control WKGD, Wkgdx With Roast & Hold Option SolidTimer Cycle Normal Roast Cooking Roast and Hold Cycle Timer Cycle Roast & Hold Cooking Oven Cool Cycle Solid State Temperature Control Roast & Hold Standard on Computer Model Roast Cycle Normal CookingFull Size GAS Convection Ovens Electrical Operation Temperature and Time Cycle Cooking Oven Cool Cycle Computer Control ModelSchematics WKG, Wkgx Mechanical KX ControlsWKG, Wkgx Mechanical KX Controls, Roast & Hold Option WKGD, Wkgdx Solid State Temperature Control Full Size GAS Convection Ovens Electrical Operation WKGC, Wkgcx Computer Control Roast & Hold Standard Wiring Diagrams Full Size GAS Convection Ovens Electrical Operation WKG, Wkgx Mechanical KX Controls, Roast & Hold Option Full Size GAS Convection Ovens Electrical Operation WKGD, Wkgdx Solid State Temperature Control Full Size GAS Convection Ovens Electrical Operation Full Size GAS Convection Ovens Electrical Operation Full Size GAS Convection Ovens Electrical Operation WKGC, Wkgcx Computer Control Roast & Hold Standard Full Size GAS Convection Ovens Electrical Operation Troubleshooting ALL ModelsError Codes Computer Control Models onlyCondensed Spare Parts List Description