KitchenAid KSSC42FTS, KSSC48FTS Door Panels for Dispenser Models, To remove the dispenser frame

Door Panels for Dispenser Models

The freezer panel should not weigh more than 40 lbs (18.1 kg). The refrigerator panel should not weigh more than 50 lbs (23 kg).

Dispenser Frame (Classic series dispenser models)

The dispenser frame attaches to the panel with 4 screws.

To remove the dispenser frame:

	A
¹⁄₂"
(1.27 cm)
¹⁄₄" thick	Freezer
	Door
plywood
	(Dispenser)
14¹⁄₄"	10⁷⁄₈"
(36.2 cm)
	(27.6 cm)
	Dispenser
	cutout is
	centered
	left-to-right
33³⁄₄"
(85.7 cm)	3¹⁄₄"
	(8.3 cm)
⁷⁄₁₆"	¹⁄₂"
(1.1 cm)
	(1.27 cm)

B

Refrigerator

Door

70⁷⁄₁₆"

(178.9 cm)

3¹⁄₄"

(8.3 cm)

Location and offsets of raised wood panel

¹⁄₂"

(1.27 cm)

⁷⁄₁₆"

(1.1 cm)

¹⁄₄" thick plywood

¹⁄₂"

(1.27 cm)

1.Remove the four screws attaching the frame.

2.Pull the dispenser frame from the decorative panel.

3.To replace the frame, hold the frame to the panel and replace the screws.

A

Model	A	B
36	14¹⁄₄" (36.2 cm)	19¹⁄₄" (48.9 cm)
42	16³⁄₄" (42.6 cm)	22³⁄₄" (57.8 cm)
48	19¹⁄₄" (48.9 cm)	26¹⁄₄" (66.7 cm)

NOTES:

■Dispenser cutout is centered left-to-right.

■If the standard handle is used, the handle side offset of both panels should be 3¹⁄₄" (8.25 cm) to all for finger clearance.

■If an extended handle is used, the handle side offset of both panels should be ⁷⁄₁₆" (1.1 cm). Make sure the refrigerator location allows the doors with extended handles to open to 90 degrees. See “Door Swing Dimensions.”

■The dashed lines in the illustration represent the location and offsets of raised wood panel.

A. Dispenser frame

The dispenser frame overlaps the dispenser cutout by ⁵⁄₁₆"

(0.78 cm) on each side and ¹⁄₂" (1.27 cm) on the top and bottom.

AA

A. ¹⁄₂" (1.27 cm) Overlap

17