3.If the oven bake flame needs to be adjusted, locate the air shutter near the center rear of the storage drawer compartment. Use a
A
B
A. Air shutter adjustment screw
B. Air shutter
4.Press CANCEL when finished.
5.Reinstall the bake burner cover.
Check Operation of Oven Broil Burner
1.Close the oven door to the broil stop position.
2.Press the BROIL pad. “BROIL” and “HI” and “LOW” will show in the display.
3.Press the Quickset pad the control panel next to LO to start.
The igniter used to light the bake burner will glow. Once the igniter is hot the oven bake burner should light. Under certain conditions it may take up to 60 seconds for it to light.
Adjust Oven Broil Burner Flame (if needed)
Look through oven window to check broil burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of
If flame needs to be adjusted:
1.Use a
2.Adjust the air shutter as need.
3.Tighten air shutter adjustment screw.
A
B
A. Air shutter adjustment screw
B. Air shutter
4.Press CANCEL when finished.
Replace Oven Racks and Storage Drawer
Replace oven racks in oven cavity. Replace storage drawer.
To Replace Storage Drawer:
1.Fit the ends of the drawer glides into the rails in the range.
2.Lift up the front of the drawer and gently push in to the first stop position.
3.Lift drawer up again and push until drawer is closed.
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Dispose of/recycle all packaging materials.
4.Check that the range is level. See “Level Range.”
5.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by protective shipping material. Dry thoroughly with a soft cloth. For more information, see the “Range Care” section of the Use and Care Guide.
6.Read the Use and Care Guide.
7.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.
If range does not operate, check the following:
■Household fuse is intact and tight, or circuit breaker has not tripped.
■Range is plugged into a grounded 3 prong outlet.
■Electrical supply is connected.
■See “Troubleshooting” in the Use and Care Guide.
8.When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open.
■If the gas supply line shutoff valve is closed, open it, then repeat the
■If the gas supply line shutoff valve is open, press the CANCEL button on the oven control panel and contact a qualified technician.
11