KitchenAid W10154991A Electrical Requirements U.S.A.Only, Electrical Connection

Page 7

Electrical Requirements - U.S.A.Only

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge is in accordance with local codes.

Do not use an extension cord.

Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/ NFPA 70-latest edition and all local codes and ordinances.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service technician if you are in doubt as to whether the appliance is properly grounded. Do not modify the power supply cord plug. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.

Electrical Connection

To properly install your range, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.

Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located on the oven frame behind the storage drawer panel. Refer to the figures in the “Product Dimensions” section of the “Location Requirements” section.

This range is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire UL listed, 40- or

50-amp power supply cord (pigtail) (see Range Rating chart below). If local codes do not permit ground through the neutral, use a 4-wire supply cord rated at 250 volts, 40 or 50 amps and investigated for use with ranges.

Range Rating*

 

Specified Rating of

 

 

Power Supply Cord Kit

 

 

and Circuit Protection

 

 

 

120/240 Volts

120/208 Volts

Amps

 

 

 

8.8 - 16.5 KW

7.8 - 12.5 KW

40 or 50**

16.6 - 22.5 KW

12.6 - 18.5 KW

50

 

 

 

*The NEC calculated load is less than the total connected load listed on the model/serial rating plate.

**If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use kits that specify use with a nominal 1³⁄₈" (34.93 mm) diameter connection opening.

A time-delay fuse or circuit breaker is recommended.

The range can be connected directly to the fused disconnect (or circuit breaker box) through flexible or nonmetallic sheathed, copper or aluminum cable. See “Electrical Connection.”

Allow 2 to 3 ft (61.0 cm to 91.4 cm) of slack in the line so that the range can be moved if servicing is ever necessary.

A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction box).

Wire sizes and connections must conform with the rating of the range (40 amps).

The wiring diagram is located on the underside of the storage drawer or below the warming drawer in a clear plastic bag.

If connecting to a 4-wire system:

This range is manufactured with the ground connected to the cabinet. The ground must be revised so the green ground wire of the 4-wire power supply cord is connected to the cabinet. See “Electrical Connection.”

Grounding through the neutral conductor is prohibited for new branch-circuit installations (1996 NEC); mobile homes; and recreational vehicles, or an area where local codes prohibit grounding through the neutral conductor.

When a 4-wire receptacle of NEMA Type 14-50R is used, a matching UL listed, 4-wire, 250-volt, 40-amp, range power supply cord (pigtail) must be used. This cord contains 4 copper conductors with ring terminals or open-end spade terminals with upturned ends, terminating in a NEMA Type 14-50R plug on the supply end.

The fourth (grounding) conductor must be identified by a green or green/yellow cover and the neutral conductor by a white cover. Cord should be Type SRD or SRDT with a UL listed strain relief and be at least 4 ft (1.22 m) long.

4-wire receptacle (14-50R)

The minimum conductor sized for the copper 4-wire power cord are:

40-amp circuit

2 No.-8 conductors

1No.-10 white neutral

1No.-8 green grounding

If connecting to a 3-wire system:

Local codes may permit the use of a UL listed, 3-wire,

250 volt, 40-amp range power supply cord (pigtail). This cord contains 3 copper conductors with ring terminals or open-end spade terminals with upturned ends, terminating in a NEMA Type 10-50P plug on the supply end. Connectors on the appliance end must be provided at the point the power supply cord enters the appliance. This uses a 3-wire receptacle of NEMA Type 10-50R.

3-wire receptacle (10-50R)

7

Image 7
Contents W10154991A DE 30 76,2 CMTable DES Matières Range SafetyWhat to do if YOU Smell GAS ToolsandParts Installation RequirementsLocation Requirements Slide-in Range Mobile Home Additional Installation RequirementsProduct Dimensions Freestanding Range Mobile home installations requireFreestanding Ranges Installation ClearancesSlide-In Ranges Electrical Requirements U.S.A.Only If connecting to a 4-wire systemIf connecting to a 3-wire system Local codes may permit the use of a UL listed, 3-wireGas Supply Line Electrical Requirements -Canada OnlyGas Supply Requirements Type of GasGas Pressure Regulator Gas Supply Pressure TestingCountertopPreparation Burner Input RequirementsSlide-In Ranges Installation InstructionsUnpack Range MeasureforProperHeightInstallAnti-TipBracket Adjust LevelingLegsTo Remove Warming Drawer RemoveWarming DrawerVerifyAnti-Tip Bracket Location Level RangeElectrical Connection -U.S.A.Only Power Supply CordDirect Wire Style 1 Power supply cord strain reliefStyle 2 Direct wire strain relief Wire connection Power Supply CordWire Connection Direct Wire Direct Wire Installation Copper or Aluminum WireTypical rigid pipe connection Make Gas ConnectionComplete Connection Initial lighting and gas flame adjustmentsElectronicIgnitionSystem Typical flexible connectionReplace Oven RacksandWarmingDrawer Complete InstallationIf range does not operate, check the following GAS ConversionsLPGas Conversion To Convert Gas Pressure RegulatorGas orifice spuds are stamped with a number, marked with Reinstall the cap onto the regulatorTo Convert TripleTier Flame Burners on some models To Convert Standard Surface BurnersNaturalGas Conversion To Convert TripleTier Flame Burner on some models Votre sécurité et celle des autres est très importante Sécurité DE LA CuisinièreExigencesd’emplacement Exigences D’INSTALLATIONOutillageetpièces Cuisinière encastrée Dimensions du produit Cuisinière autoportanteCuisinières autoportantes Dégagements de séparation à respecterCuisinières encastrées Gaz naturel Spécifications électriquesSpécifications del’alimentation engaz Type de gazDétendeur de gaz PréparationduplandetravailCanalisation de gaz Débit thermique des brûleursRéglage despieds de nivellement Instructions DinstallationDéballagede lacuisinière MesurespourunehauteurappropriéeInstallation de la brideantibasculement Raccordement à la canalisation degaz Vérificationdelemplacement de labride AntibasculementRetraitdutiroir-réchaud Réglage del’aplomb delacuisinièreCompléter le raccordemant Installée sur le brûleur avant gaucheRaccordement typique par raccord flexible Cuisinière encastréeSi le brûleur ne sallume pas correctement Système dallumageélectroniqueAllumage initial et réglages des flammes Brûleur à flamme TripleTierConversion pourlalimentationaupropane Réinstallationdes grillesdufouret Dutiroir-réchaudAcheverlinstallation Conversions Pour Changement DE GAZImportant Ne pas enlever le détendeur Conversion des brûleurs standard de la table de cuissonDétendeur Enlever la plaque associée au gicleur externe Conversionpourlalimentation augaz naturel Chiffre gravé Holes in bracket Trous dans la bride All rights reserved

W10154991A specifications

The KitchenAid W10154991A is a versatile kitchen appliance designed to simplify meal preparation while enhancing culinary creativity. This food processor is equipped with innovative features and technologies that make it an essential addition to any modern kitchen.

One of the main features of the W10154991A is its powerful motor, which allows for quick and efficient processing of various ingredients. Whether you're chopping vegetables, shredding cheese, or mixing dough, this food processor can handle a wide range of tasks with ease. The motor's robust performance ensures that you can complete your cooking projects in a fraction of the time compared to using manual methods.

Another significant characteristic of the KitchenAid W10154991A is its variety of attachments and blades. The food processor comes equipped with multiple blades for different functions, including slicing, shredding, and chopping. This versatility enables users to achieve the desired texture and consistency for their recipes, all with one appliance. The included attachments are designed for easy installation and removal, making the transition between tasks seamless.

The design of the W10154991A also speaks to its user-friendly nature. It features a large capacity bowl, allowing you to process larger quantities of ingredients at once, which is ideal for meal prepping or when entertaining guests. The bowl is made from durable materials that can withstand the rigors of daily use while remaining easy to clean, as many parts are dishwasher safe.

Safety is a priority in the design of the KitchenAid W10154991A. It includes a safety lock feature that ensures the processor will not operate unless the bowl and lid are correctly secured. This feature gives users peace of mind while using the appliance and helps prevent accidents in the kitchen.

In terms of technology, the KitchenAid W10154991A employs a straightforward control panel that includes several speed settings. This means you can select the perfect speed for the task at hand, whether you need a gentle pulse or a steady chop. The intuitive design of the control panel makes it accessible for cooks of all skill levels.

In conclusion, the KitchenAid W10154991A food processor is an excellent investment for anyone looking to enhance their cooking experience. With its powerful motor, versatile attachments, user-friendly design, and safety features, this appliance stands out in the crowded market of kitchen gadgets. It empowers users to explore their culinary potential while simplifying time-consuming tasks in the kitchen.