Removable Mid Level and Culinary Tool Racks
The row of tines on the
To adjust the fold-down tines:
1.Grasp the tip of the tine that is in the tine holder.
2.Gently push the tine out of the holder.
3. Lay the tines down, toward the center of the rack.
The removable racks allow you to wash larger items such as stock pots, roasters, and cookie sheets in the lower level rack.
IMPORTANT: Remove dishes prior to removing the mid level rack from dishwasher.
To remove the rack:
1.To access track stops, pull the rack forward until it stops and clicks into place.
A
B
A. Track stop
B. Track
SURE-HOLD® Light Item Clips
The light item clips hold lightweight plastic items such as cups, lids, or bowls in place during washing.
To move a clip:
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
Removable Mid Level Rack Inserts
Your dishwasher has two removable mid level rack inserts which allow you to adjust the rack to the type of load you are washing.
A
B |
2.To open track stops, flip the track stop to the outside of the track.
3.After opening both track stops, slide front wheels up and out of the slot in track. Continue to pull rack forward in track and slide the back wheels up and out of the track.
4.Close track stops.
5.Slide rack tracks back into dishwasher.
To replace the rack:
1.Gently pull rack tracks forward in dishwasher until they stop and click into place.
2.To open track stops, flip the track stop to the outside of the track.
3.Place the back rack rollers on each side of the rack into the track slot and roll the rack back into the tracks.
4.Insert front rack rollers on each side of the rack into the rack slots.
5.Close track stops on both sides of rack and slide rack back into dishwasher.
Culinary Tool Rack
The culinary tool rack is designed with 2 movable baskets to hold extra silverware, knives and cooking utensils.
Install the baskets in this up position when you have extra silverware and flatware to wash.
A. Removable rack inserts
B. Insert holding clips
To install rack inserts:
Place the insert end legs under the front or back rack wire as shown below. Push down on the center insert wire until it slides into the holding clip on either side of the center in the bottom of the rack.
A |
B |
A. Lift removable insert wire to remove from holding clips. B. Holding clips
To remove inserts:
Lift up on the insert wire located toward the center of the rack to release the insert from the holding clips. Lift insert out of rack.
Up position
Install the baskets in this down position when you have extra silverware, knives, or utensils requiring more room to wash.
IMPORTANT: When you are using the culinary tool baskets in the down position, the mid level rack must also be in the lowest position.
Down position
7