ENGLISH 69
Machine actions
Causes
Solutions
The machine grinds the | There is no water. | Fill the water tank and prime the circuit | |
coffee beans but no coffee |
| (please refer to chapter “Manual rinse | |
comes out. |
| cycle”). | |
(See note) |
|
| |
The brew group is dirty. | Clean the brew group (“Weekly clea- | ||
| |||
|
| ning of brew group” chapter). | |
|
|
| |
| This might occur when the machi- | Brew a few coffees as described in | |
| ne is automatically adjusting the | chapter “Saeco Adapting System”. | |
| dose. |
| |
|
|
| |
| The dispensing spout is dirty. | Clean the dispensing spout. | |
|
|
| |
Coffee is too weak. | This might occur when the machi- | Brew a few coffees as described in | |
(See note) | ne is automatically adjusting the | chapter “Saeco Adapting System”. | |
| dose. |
| |
|
|
| |
| The coffee is too coarse. | Change coffee blend or adjust the | |
|
| grind as explained in chapter “Adju- | |
|
| sting the ceramic coffee grinder”. | |
|
|
| |
Coffee is brewed slowly. | The coffee grind is too fine. | Change coffee blend or adjust the | |
(See note) |
| grind as explained in chapter “Adju- | |
|
| sting the ceraminc coffee grinder”. | |
|
|
| |
| Circuits are clogged. | Perform a descaling cycle. | |
|
|
| |
| The brew group is dirty. | Clean the brew group (please refer to | |
|
| chapter “Weekly cleaning of the brew | |
|
| group”). | |
|
|
| |
Coffee leaks out of the | The dispensing spout is clogged. | Clean the dispensing spout and its | |
dispensing spout. |
| holes. | |
|
|
|
Note:
These problems can be considered normal if the coffee blend has been changed or if the machine has just been installed. In this case wait until the machine performs a