KitchenAid KUWO24LSBX manual Wine Racks, Stocking the Wine Cellar, Lighting the Wine Cellar

Wine Racks

To Remove and Replace the Wine Racks

1.Pull the rack forward until it stops. Push in on the tabs to release the rack. Continue pulling the rack forward and lift it up and out of the rack supports.

A

A

A.Tabs

2.Replace the rack by inserting the rack into the supports and sliding it toward the rear of the wine cellar.

To Remove and Replace the Bottom Rack

1.Lift the rack (front and back) up and pull straight out to remove.

2.Replace the rack by pushing it straight back and over the stop. Continue pushing the rack straight back and evenly until it is in place.

Stocking the Wine Cellar

NOTE: For optimum wine storage, place white wines at the top of the wine cellar, light red wines in the center and red wines at the bottom.

To Stock the Wine Cellar

1.Start stocking the wine cellar with the bottom display rack.

2.Starting on the left-hand side, place the first bottle on the bottom of the rack with the neck of the bottle facing the back of the wine cellar.

3.Place the next bottle on its side with the neck of the bottle facing the front of the wine cellar.

4.Alternate in this manner until the display rack is full.

5.Pull the next rack forward.

6.Starting on the left-hand side, place the first bottle on the rack with the neck of the bottle facing forward.

7.Place the next bottle on the shelf with the neck of the bottle facing the rear of the wine cellar.

8.Continue alternating in this manner until the rack is full.

9.Slide the rack into place and continue stocking each remaining rack as described above.

Lighting the Wine Cellar

The wine cellar has an interior light that comes on any time the door is opened. You may also turn the light on at any time by opening the door and pressing the exterior switch located beside the temperature control knob on the base grille.

NOTE: Leaving the light on for an extended period of time will slightly increase the temperature of the wine cellar.

9