Wolfgang Puck BDFR0060 manual Front

HSN_DeepFryerManual 6/21/10 10:48 AM Page 11

Assembling Your Deep Fryer

Assembling Your Fryer

Drain Tap Cap

figure 1

Front

figure 2

figure 3

figure 4

figure 5

figure 6

Assembling your Deep Fryer for Use

1Place the Deep Fryer housing on a stable, level surface.

2Ensure that all components of your Deep Fryer are completely dry prior to use to avoid risk of injury due to spattering.

3Insert the oil pot into the Deep Fryer housing ensuring that the front of the pot (the front is indicated by the tap) is placed at an angle into the housing. (See figure 1).

4Place the Oil Pot Filter Screen into the Oil Pot. Ensure that the raised end of the filter screen is towards the front of the Fryer Pot. (See figure 2).

5Line up the Heater Control Unit into the grooves on the rear of the Deep Fryer housing. Your Deep Fryer is equipped with a safety microswitch which will not allow the Heater Control Unit to work unless it is properly seated into both grooves in the Housing. (See figure 3).

6Add the appropriate amount of oil to the Oil Pot. Do not fill with oil above the maximum level or below the minimum level marked on the inside of the Deep Fryer pot. (See figure 4).

7Attach the Magnetic Release Power Cord into the receptacle on the Heater Control Unit. Only use the approved receptacle marked MC-316 in your unit. To attach the receptacle ensure that the marking “THIS SIDE IS UP” is facing up in order to line up with the plug receptacle on the Heater Control Unit. (See Figure 5).

8Unfold the Basket handle and ensure that it is locked into place. The ends of the handle rods must be inserted in the loop of the Basket and placed behind the metal stem in order to lock in place. A serious burn injury can occur if your handle is not properly locked in place.

(See figure 6).

9Place the Basket into the Oil Pot. (See figure 7).

10To drain oil, lift and rest the Frying Basket on the Oil Pot.

Drain tap lock

Drain tap

Drain tap cap

Figure 1 Figure 2

Your Wolfgang Puck Deep Fryer is equipped with a Safety Drain Cap. Your Drain Tap Cap should always be in place when using your deep fryer or when storing oil in the tank (see figure 1). The following directions outline the use of the Drain Tap.

1Place Drain Tap Cap on Drain Tap by turning counter clockwise until tight. Always ensure that your Drain Tap Lock is closed whenever using your Deep Fryer, or when storing oil in your tank. Never unlock the Drain Tap Lock with the Tap Cap on the Drain Tap.

2To remove Drain Tap Cap first ensure that the Tap Lock is in the closed position. Turn Drain Cap clockwise to remove (see figure 2) and set aside.

3Place container under tap and unlock the Drain Tap Lock to begin draining oil. Never drain hot oil, or while or deep fryer is plugged in.

4Your Drain Tap should be washed in warm soapy water and allowed to dry thoroughly.

figure 7 11 12