Sunbeam EM4820 manual Care and Cleaning, Brew head rubber seal, Cup warming plate and exterior

Page 21

Care and Cleaning (continued)

Brew head rubber seal

This seal is located in the brewing head and creates a seal against the filter handle when making an espresso.

Note: When your Sunbeam Café Crema® II is not being used, we recommend that you do not leave the filter handle attached to the machine as this will reduce the life of the seal.

Over time this seal loses its elasticity and will require replacement – usually every 6-12 months. Signs that the seal is deteriorating are when: the filter handle rotates to the far right and feels loose, or steam escapes from around the brewing head during use.

The cup warming plate and exterior

Wipe over the unit with a damp cloth and wipe dry. Do not use abrasives or metal scourers, as these will scratch the exterior surface.

Steam wand

The steam wand needs to be cleaned each time you texture milk or heat any other liquid. To clean the steam wand, wipe with a damp cloth and for the froth attachment, simply rinse it under warm water.

Note: After each use we recommend that a small amount of steam is purged from the steam wand.

On a monthly basis we recommend thoroughly cleaning the steam wand.

To do this soak the wand/arm in water with the stainless jug resting on the drip tray. Ensure that the water level in the jug is over the wand. Run steam through the wand for 30 seconds, then leave to soak overnight.

In the morning turn the machine on and run steam through the wand again for 30 seconds.

Important: Do not wash parts in the dishwasher. Do not immerse the unit in water.

Important: Should your steam wand become blocked, supplied with your espresso machine is a cleaning wire.

The cleaning wire for the steam wand is located under the base of the water reservoir (37).

With the cleaning wire insert it into the hole in the base of the steam wand (38).

Should the steam wand remain blocked unscrew the steam nozzle from the steam arm (39). Clean the steam nozzle by once again using cleaning wire and then flush under running water.

19

Page 20 Page 22
Image 21
Page 20 Page 22
Contents EM4820 Café CremaSub Heading HeadingImportant instructions retain for future use ContentsFor examination, repair or adjustment Sunbeam’s Safety PrecautionsWhat makes a good coffee? About espresso coffeeWarming plate Features of your Sunbeam Café CremaAllows up to 9 espresso cups to be warmed before use Non-slip rubber feet1L removable water reservoir Power button Hot water / steam selectorOperating dial Silicone coverThermoblock heating system BAR pumpOperations Guide for your Café Crema Press power button to turn machine onFilling the water reservoir Preparing the espresso machineMaking an Espresso Operations Guide for your Café CremaTexturing milk Hot Water Remove the water reservoir from the espresso machine Secrets to the perfect cup Easy steps for texturing milk Important cleaning instructions for the steam wand/armPosition, empty the container, then resume the operation Before using your Café CremaPreparing an espresso Functions of your Café CremaSteam function can be used for texturing/ frothing milk Functions of your Café CremaTurn the dial to the pre-heat position Operating dial to the pre-heat position and remove the jugCleaning the steam wand Care and Cleaning Drip trayBrewing head, filters & group handle Brew head rubber seal Care and CleaningCup warming plate and exterior Steam wandDescaling Descaling solution Descaling the espresso machineDescaling Problem Possible cause What to do Trouble Shooting guideGroup handle No coffee runs throughCoffee is too cold Trouble Shooting guideUneven cup filling Espresso tastes burntLoud noise 190mL cup Hot water to taste Single or double espresso RecipesCaffe Latte RecipesPage Page Month Replacement Guarantee AustraliaNew Zealand Need help with your appliance?
Top Page Image Contents