Sunbeam EM4820 manual Before using your Café Crema

Page 16

Before using your Café Crema® II

Before using your Sunbeam Café Crema® II for the first time or if you have not used it for some time, rinse the machine by running water through without coffee in the group handle, as follows:

Note: Throughout these instructions the numbers you see highlighted and in brackets refer back to the diagrams at the start of this instruction manual.

•Open the lid of the water reservoir (1) and fill with cold water (2). Alternatively you can open the lid and remove the water reservoir using both hands (3). Then fill with cold water (4).

•Replace the water reservoir firmly into the unit (5) and close lid.

•Insert the power plug into a 230-240V AC

power outlet and turn the power () on. Start the unit (6). The red power () light will illuminate and flash to indicate it is warming up.

•Place one of the filters in the group handle

(7). Then position the group handle on the machines brewing head (8).

•To ensure that the group handle is in the correct position, turn the handle so it points to the left and place the group handle flat against the brewing head (8), then turn the handle towards the right (9), as far as it can go.

Note: Do not over tighten.

•Place a sufficiently large container under the group handle pouring spouts (10).

•When the power button has stopped flashing and is completely illuminated, the machine is ready for the next step.

•Turn the dial to the espresso () setting (11) and allow all the water in the water reservoir to run through.

•If necessary, you may need to stop the operation by turning the dial to the off

() position, empty the container, then resume the operation.

Note: Make sure that the water reservoir is clean and free of any debris, as any fine particles can block the water flow.

14

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Café Crema EM4820Heading Sub HeadingContents Important instructions retain for future useSunbeam’s Safety Precautions For examination, repair or adjustmentAbout espresso coffee What makes a good coffee?Features of your Sunbeam Café Crema Warming plateAllows up to 9 espresso cups to be warmed before use Non-slip rubber feetPower button Hot water / steam selector 1L removable water reservoirOperating dial Silicone coverBAR pump Thermoblock heating systemPress power button to turn machine on Operations Guide for your Café CremaFilling the water reservoir Preparing the espresso machineOperations Guide for your Café Crema Making an EspressoTexturing milk Hot Water Remove the water reservoir from the espresso machine Secrets to the perfect cup Important cleaning instructions for the steam wand/arm Easy steps for texturing milkBefore using your Café Crema Position, empty the container, then resume the operationFunctions of your Café Crema Preparing an espressoFunctions of your Café Crema Steam function can be used for texturing/ frothing milkTurn the dial to the pre-heat position Operating dial to the pre-heat position and remove the jugCleaning the steam wand Drip tray Care and CleaningBrewing head, filters & group handle Care and Cleaning Brew head rubber sealCup warming plate and exterior Steam wandDescaling solution Descaling the espresso machine DescalingDescaling Trouble Shooting guide Problem Possible cause What to doGroup handle No coffee runs throughTrouble Shooting guide Coffee is too coldEspresso tastes burnt Uneven cup fillingLoud noise Recipes 190mL cup Hot water to taste Single or double espressoRecipes Caffe LattePage Page Australia Month Replacement GuaranteeNew Zealand Need help with your appliance?
Top Page Image Contents