Descaling (continued)
17.After 1 minute, stop the machine by
turning the operating dial to the off (
) position.
18.Leave the machine off for
19.Turn the dial to the espresso (
) setting and allow ½ of the rest of the descaler solution to run through the brewing head.
20.Turn the dial to the 
) position. Place the steam wand over the drip tray.
21.Once the power button is completely illuminated, turn the dial to the hot water (
) setting.
22.Allow the hot water to run through the wand for 2 minutes. Return the dial to the off (
) position.
23.Turn the dial to the espresso (
) setting and allow the remaining solution in the water reservoir to run through the brewing head.
24.Remove the water reservoir from the machine and rinse thoroughly under running water, ensuring that all traces of the descaling solution is removed. Fill the water reservoir with clean water and place onto the machine.
25.Run two (2) full water reservoirs through the brewing head. Refill the water reservoir and run the steam nozzle for
Note: Ensure that you continue to run water through the machine until the water runs clean and clear.
26.When this is finished, remove the water reservoir and set aside. Remove the water containers and give the machine a good wipe over.
27.Turn the machine upside down. The machine should now be on the warming plate resting on the cloth/tea towel once again.
Important: The brewing head will be hot from the descaling process. Allow this to cool down before replacing any parts.
28.Carefully replace the rubber seal, filter, washer and screw. Tighten well.
29.Turn the machine upright, so that it is now sitting correctly on the bench.
30.Replace the drip tray.
31.Fill the water reservoir with water and position it on to the machine.
21